Techly I-LED LUMES Quick Start Manual

EN
I-LED LUMES
Dear Customer, thank you for choosing our LED lamp. Please read this
instruction carefully before use to fully enjoy the advantages of this
product. This operation instruction is part of the product and contains
important noted on handling.
PRECAUTIONS FOR USE
• Do not expose the LED unit to fire or high temperature.
• Do not attempt to dissemble the LED unit to avoid risk of electronic shock
or alternation of water proofing. Failure to comply will automatically void
warranty.
• Use only the charger supplied in the package; to extend the battery life the
first charge of this item is for 8 hours.
• This product is not a toy and it should be not used without adult supervision.
It is forbidden to use the lamp during the recharging phase.
Please wait until charging is complete before turning on and
using the lamp.
CHARGER
• The LED indicator light on the base will light up red while charging and turn
green when the battery is fully charged.
• Do not use charger near a heat source or expose to fire; do not try to open the
charger.
• Keep the charger out of the reach of children.
• Do not touch the charger while charging and do not use the charger outdoors
because it is only for internal use and it is not waterproof.
• Disconnect the charger after the charging is complete.
INSTRUCTION FOR USE
• The charging point and ON/OFF button is on the bottom side of the item.
• Turn on, press the ON/OFF button, this will start at the last mode which was
previously selected.
• To turn off, simply press the ON/OFF button.
• For first use, flick the switch on the bottom to activate the functions.
WWW.TECHLY.COM
REMOTE CONTROL FUNCTIONS
• Power ON in red and OFF in black
• Brightness control (in static mode)
• Speed control (in flash, strobe, fade, smooth mode)
• Quick select of 16 static colors
• Flash mode: flashing with 7 colors continuously
• Strobe mode: blinking in white light
• Fade mode: blinking with 7 colors lights
• Smooth mode: flowing of full colors spectrum
• Battery: button battery 3V CR2025 included
• To active the remote control pulls the power separation film from the battery
unit at the end of the unit
I-LED LUMEXL
• If the unit has been out of the use for some time, recharge the unit first and
then press the green (G) button of the remote for 12secons for setting the
device to factory setting. Alternatively, charge it once a month to prolong the
service live of the product.
SAFETY GUIDELINES
• Please note that the remote control for this item includes a coin battery:
keep out of reach of children. Swallowing of the batteries can be extremely
dangerous.
• Please note: the remote control is not waterproof and not intended for
children.
MAINTENANCE AND CLEANING
• Servicing or repairing must only be carried out by specialist or specialist
workshop.
• Never open the product's casing (except for the procedures described in
these operating instructions for insertion the charger plug or battery of the
remote control). A soft, dry and clean cloth is sufficient for cleaning the
outside. Never use any abrasive cleaning agents, alcohol or other chemical
solution that would damage the casing (discoloration).
PACKAGE CONTENTS
• LED lamp desk x1pc • Power supply x1pc
• Remote control x1pc • User's manual x1pc
WEEE directive, otherwise contaminative and hazardous substances can
pollute the environment.
WWW.TECHLY.COM website in the product page.
MULTICOLOR LED LAMP
Brightness
Speed
Quick
Select
(16 Colour)
In compliance with EU Directive WEEE this product is marked with
this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a
separate collections system for these products in compliance with
With the CE sign, Techly ensures that the product is conformed to
®
the basic European standards and directives.
The full text of the EU Declaration of Conformity is available on the
Power Off
Power On
Flash
Strobe
Fade
Smooth