Advertisement
Quick Links
Advertisement
Summary of Contents for AT&T Z7308 H01B
- Page 1 AT&T CIB 3032 Z7308 H01B) ATTENDANT CONSOLE (3162)
- Page 2 CIB 3032 (Z7308 H01B) Attendant Console (3162) The attendant console (Figure 1) is a console for a large communications system. Up to 30 outside lines and 70 voice terminals may be accessed by this attendant console. Assembling Your Attendant Console 1.
- Page 3 Attaching Adapter Plate Turn the attendant console over. Attach the adapter plate to the bottom of the console by sliding the adapter plate’s mounting slots under the attendant console’s mounting tabs (see Figure 2). Make sure the largest opening on the adapter plate is over the area for the “OTHER”...
- Page 4 Mounting Your Attendant Console 1. Check to see that your desk stand is adjusted to the lowest position. The support bar (see Figure 3) should be in the groove for the lowest position (see Figure 4). If it is not in the lowest position, adjust it now by following the instructions in the next section, “Adjusting the Desk Stand”.
- Page 5 adapter plate mounting tabs Figure 5. Attendant Console with Adapter Plate (Bottom View) “A” mounting slots Figure 6. Desk Stand Mounting Slots 3. Gently slide the stand upward so that the mounting tabs on the adapter plate fit firmly into the smaller part of the three mounting slots on the desk stand.
- Page 6 Attaching Cords to Console Body Check to see that one end of the handset cord is attached to the hand- set. If it is not attached, plug one end into the handset now. 2. Plug the other end of the handset cord into the jack on the bottom right corner of the console (see Figure 7).
- Page 7 Attaching Voice Terminal Power Supply 1. Plug the modular voice terminal cord (marked D8W on its jack) into the voice terminal jack on the Z400F adapter (see Figure 8). voice terminal jack power jack modular voice terminal cord output jack power supply cord Figure 8.
- Page 8 modular voice terminal extension cord (D8AF) Z400F adapter modular terminal jack Figure 9. Attaching Adapter to Building Wiring 4. Refer to the exploded view in Figure 10 to make sure all the components are installed correctly. modular voice terminal modular voice extension cord terminal cord (D8W) (D8AF)
- Page 9 Testing Your Attendant Console The test/program (T/P) switch on the left side of the attendant console (see Figure 11) can be used to test the lights and the ringer. It has three positions: T– test position center (dot)– normal operating position P–...
- Page 10 Inserting and Removing Labels Inserting 1. Refer to Figure 12 to see which labels go with which columns. plain multicolored labels labels Figure 12. Labels Insert the bottom of the label into the label slot above each column of touch-sensitive buttons (see Figure 12). Slide the label all the way into the slot until the appropriate box ap- pears next to the proper button.
- Page 11 Handsets for the Hearing Impaired and Noisy Locations All 3162 attendant consoles come with a handset that is hearing-aid com- patible. Two other types of handsets are also available. The R6 impaired-hearing handset (PEC 31753) has an extra amplifier to pro- vide greater volume in the earpiece.