aquaTree Quick Setup Guide Quick Setup Manual

Quick Setup Guide
Simple Steps to Get Your Aquatree Up and Growing
Date Code
Aquatree Model number: 202001-WHT Aquatree Sprout
Electrical Rating: 120V~60Hz, 0.45A
Keep this Guide!
5 Easy Steps
To Get Your Aquatree Up and Growing
1
Insert Pump Base
into tank
Place Pump Base over
Tank receiver in center
of Tankand lock into
Base.
2
Fit Tank Lid, Spout,
Extension Tube, &
Cap
3
Counterbalance
Trays on Spout
4
Connect Cords
Push Pump Cord firmly into
socket in Power adapter.
Lights may be added after
germination.
5
Add Water, Seed Mats, Seeds
CONGRATULATIONS!
may power on your Aquatree.
You are ready to grow!
For more details on planting, growing and
harvesting your Aquatree, please turn the page.
Included in Package
Insert Assembly
Graphic Here
Insert Assembly
Graphic Here
•
•
•
•
•
•
Insert Assembly
Graphic Here
To Install, Raise, and Lower Lights
You
To Install lights, align light hub parts such that they snap
together around the Extension Tube. Light Hub should
slide freely on Extension Tube. Insert Light Harness into
Light Hub. Clip lights to rim of Light Hub. Plug light cord
}
into power adapter socket.
IMPORTANT SAFETY INSTRUCTIONS
When using this Aquatree electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this Aquatree furnishing. SAVE THESE INSTRUCTIONS
(No tools required)
1. To reduce the risk of electric shock, the Aquatree has a specific plug.
Do not change the plug in any way.
DANGER
2. Always unplug the Aquatree from electrical outlet before cleaning.
WARNING
electric shock, or injury to persons:
3. Unplug Aquatree from outlet before putting on or taking off parts.
5. Use Aquatree only for its intended use as described in the instructions. Do
not use attachments not recommended by manufacturer.
6. Never operate Aquatree if it has a damaged cord or plug, if it is not working
properly, if it has been dropped and damaged, or if it has been dropped in
water. If any of these conditions occur/exist, contact customer servce.
7. Keep cord away from heated surfaces.
8. Never operate furnishing with unit over-filled. Utilize water lines guides
as instructed.
9. Never drop or insert any object into any electrical openings.
10. Do not use outdoors.
11. Do not operate where aerosol (spray) products are being used or where
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
Place Your Aquatree...
On a sturdy, water-tolerant surface
Near a standard electrical outlet, per local
regulations
In a 65-76°F (16-24°C) environment (optimal)
Away from reach of children or pets
Away from direct sources of heat (e.g., stove,
furnace vents) or cold (e.g., window drafts, A/C
vents)
Aquatree does not need additional light or a
sunny window. In fact, too much direct sunlight
can overheat your plants
oxygen is being administered.
12. Do not touch moving parts or hot parts such as pumps, lights, reflective
surfaces, and the like.
– to reduce risk of electric shock:
13. To disconnect, remove plug from outlet.
14. Do not place or submerge adapter, controller, cord, plug, or Light in water
– to reduce risk of burns, fire,
or other liquid to clean it.
15. Do not allow water to contact LED Lights.
16. Use only approved and supplied parts and accessories. Use only Aquatree
LED Lights with this Aquatree model. Use of any other kind of accessory is
not recommended.
17. Do not use Aquatree for other than intended purpose.
18. This product is intended for household and residential use only. This product
is not approved for commercial applications.
19. If any part of the Aquatree is damaged, it must be replaced by
manufacturer, its service agent, or similarly qualified technician in order to
avoid a hazard.
20. Electrical wiring must be in accordance with local regulations.
21. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of appliance by a person responsible for their safety.
22. Children should be supervised to ensure safety.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Download the Aquatree App by searching
"Aquatree" in your mobile App Store.
Order extra Seed Matts and Accessories at www.growlocal.eco
}
}
Seed Mat & Seeds
Insert Assembly
Graphic Here