Advertisement
Advertisement
Table of Contents
Summary of Contents for Crown Food Service Equipment GCTRS-16
- Page 1 INSTALLATION AND OPERATION MANUAL ROUND GAS COUNTER TILTING SKILLET MODEL: GCTRS-16 CROWN FOOD SERVICE EQUIPMENT LTD. 70 OAKDALE ROAD, DOWNSVIEW, (TORONTO), ONTARIO, CANADA, M3N 1V9 TELEPHONE: (416) 746-2358, FAX: (416) 746-8324 PRINTED IN CANADA PART NUMBER 10007R1 2004-06-23...
-
Page 2: Important Notes For Installation And Operation
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 IMPORTANT NOTES FOR INSTALLATION AND OPERATION This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. -
Page 3: Table Of Contents
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 TABLE OF CONTENTS DESCRIPTION PAGE Important Notes for Installation and Operation ........2 1.0 Service Connections . -
Page 4: Service Connections
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 1.0 SERVICE CONNECTIONS PART NUMBER 10007R1 2004-06-23... - Page 5 INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 1.0 SERVICE CONNECTIONS (Continued) Installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1, as applicable.
-
Page 6: Installation Instructions
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 2.0 INSTALLATION INSTRUCTIONS WARNING: Never use an open flame to check for gas leaks. Check all connections for leaks using soapy water before use. Ideally an exhaust system should be located directly above the appliance to remove combustion gases and steam generated by the unit. -
Page 7: Operation Instructions
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 3.0 OPERATION INSTRUCTIONS WARNING: In the event of main burner ignition failure, a 5 minute purge period must be observed prior to re-establishing ignition source. WARNING: In the event you smell gas, shut down equipment at the main shut off valve and contact the local gas company or gas supplier for service. - Page 8 INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 3.0 OPERATION INSTRUCTIONS (Continued) TO TILT SKILLET Lift lid. Pull handle forward slowly to desired position. Do not release handle as pan will fall forward and could cause hot product to splash operator.
-
Page 9: Periodic Maintenance
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 4.0 PERIODIC MAINTENANCE NOTICE: Contact the factory, the factory representative or local service company to perform maintenance and repairs. NOTICE: As a safety precaution, disconnect the power supply during cleaning or servicing. -
Page 10: Troubleshooting
INSTALLATION AND OPERATION MANUAL, ROUND GAS COUNTER TILTING SKILLET, MODEL GCTRS-16 5.0 TROUBLESHOOTING Burner does not come on: Gas supply to unit is “OFF”. Manual shut off valve is “OFF.” Thermostat is not turned “ON.” Pan not in lowest position.
Need help?
Do you have a question about the GCTRS-16 and is the answer not in the manual?
Questions and answers