Download Print this page

Wilson Electronics X100G-Flash Tag User Manual

X100G-Flash Tag User's Manual

1 Installation

The Wilson X100G-Flash Tag is mounted at the center of mass of the object to be sensed.

The sensor is capable of detecting motion in the following axes:

��

The Wilson X100G-Flash Tag module must be placed in an enclosure of non-conductive

material.

The Wilson X100G-Flash Tag will not be visible or accessible in the host product. The host must

be labeled with the following information:

Contains FCC ID: 2AHBQX21FC38 and IC: 21110-X21FC38

Contains FCC ID: 2AHBQX21FC38

IC: 21110-X21FC38

The label must be permanently affixed to the host and readily visible.

Page 1 of 3

��

Table of Contents

Do you have a question about the X100G-Flash Tag and is the answer not in the manual?

Page 1 X100G-Flash Tag User’s Manual 1 Installation The Wilson X100G-Flash Tag is mounted at the center of mass of the object to be sensed. The sensor is capable of detecting motion in the following axes: �� ...
Page 2 X100G-Flash Tag User’s Manual 3 Regulatory Notices 3.1 FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 3 X100G-Flash Tag User’s Manual 4 Radiation Exposure This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.