Fig. 32: Compressor Casing - ABB HT601672 Operation Manual

Operation Manual / A150-M58/68
7 Periodic maintenance work / 7.4 Cleaning components mechanically
7.4.3 Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
Do not breathe in these substances and avoid contact with the skin.
u
Ensure proper ventilation.
u
Observe the information in the material safety data sheet for the operat-
u
ing materials and supplies.
Wear personal protective equipment (PPE) according to the material
u
safety data sheet.
Comply with local legislation.
u
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accord-
ance with the description below.
Fig. 32: Compressor casing
72000 Compressor casing
Clean the compressor casing with steam or ultrasound. Alternatively, soak in diesel oil or
u
water containing household cleaning agent. After soaking, remove contamination with a
brush.
Dry the component completely.
u
Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the tur-
u
bocharger.
Dispose of dirty water and cleaning agents in accordance with the information in the ma-
u
terial safety data sheet.
© Copyright 2021 ABB. All rights reserved. HZTL4041_EN Rev.E January 2021