Vaughan Denmead WA0346 Installation Manual page 3

Denmead Lantern
4. Position the product onto the 5. Secure the bottom of the 6. To access the inside of the
wall by lining up the product's product to the wall using lantern. switch the product o
location holes to that of the mounting screws. Ensure the and allow to cool. Remove the
mounting screws. product is secured to the wall. screws and nials from the hood
of the lantern. Lift the hood up to
gain access. Ensure the hood is
securely xed in place afterwards.
7. To replace the bulb, unscrew 8. When the bulb has been
the glass cap on the lamp holder replaced, replace the gasket and
and remove the bulb. the glass cap ensuring the cap is
secured tightly.
NOTE: The cap must be tightly
secured, failure to secure the cap
will result in water ingress and risk
of electrical shock.
www.vaughandesigns.com
WA0346