Summary of Contents for Cal Spas Cal Designs Deluxe Spa Step WOOD118-KD
-
Page 2: Tools Required
These instructions describe the step-by-step procedure for assembling the two-tier spa step. Before beginning, check the parts that came with your step package to ensure everything you need is present. Tools Required Spa step assembly LTR20091081, Rev. A www.calspas.com... - Page 3 Slide the plastic tabs on the under- side of each step into the slots in the side panels. Spa step assembly LTR20091081, Rev. A www.calspas.com...
- Page 4 Tap the step and side panels together until they are flush. Spa step assembly LTR20091081, Rev. A www.calspas.com...
- Page 5 Place step upside down on a level surface for support. Spa step assembly LTR20091081, Rev. A www.calspas.com...
- Page 6 Insert four self-tapping screws on the bottom side of the step. Do this for all four sides. Spa step assembly LTR20091081, Rev. A www.calspas.com...
- Page 7 Turn the step right side up. Drill pilot holes for the screws using the 1/8” drill bit at the distances shown. Attach the cross-bar back support with four self-tapping screws. Spa step assembly LTR20091081, Rev. A www.calspas.com...
-
Page 8: Contact Information
CONTACT INFORMATION For customer service, please contact your authorized dealer immediately. If you need additional information and/or assistance, please contact: Customer Service Department 1462 East Ninth Street Pomona, CA 91766 Toll Free: 1-800-CAL-SPAS Fax: 1-909-629-3890 www.calspas.com Copyright 2009 LMS, Inc. All rights reserved. Duplication without written consent is strictly prohibited.
Need help?
Do you have a question about the Cal Designs Deluxe Spa Step WOOD118-KD and is the answer not in the manual?
Questions and answers