Advertisement
Quick Links
This air purifier is designed to run on 120 volt alternating current at 60 Hz,
with a maximum current of 5 amps at temperatures ranging from -10⁰C to +40⁰C
(14⁰F to 104⁰F). The plug on the unit labeled "Power Cord ~" is for the supply line
cord provided. The supply outlet in the wall must have a wired ground and if the
door of the unit is opened for any reason, do not bypass the protective earthing.
When choosing the location of your Pure Breeze Fume Hood, be sure that
the location allows the power cord to be accessible at all times. Additionally, since
the Pure Breeze Fume Hood draws air into the unit from the bottom and exhausts
clean air from the side, ensure that the unit is either mounted to the wall or ceiling
and there is at least 6 inches of clearance near the exhaust openings on the side
of the unit. A lack of airflow through the unit will decrease the efficiency of the air
purification process.
Failure to comply with the precautions listed here or any others for this
equipment may cause electrical shock or equipment failure.
24.8
20.3
25799 Jefferson Ave.
Warnings and Precautions
-Alternating Current
-Caution, Risk of Electrical Shock
Top View
Front View
37.8
Murrieta, CA 92562
1-800-VANIMAN (826-4626)
PURE BREEZE FUME HOOD
Pure Breeze Fume Hood
PN: 10370
Dimensions: 37.8"L x 24.8"W x 20.3"H
Weight: 70 lbs.
Voltage: 120V
Amperage: 5A
Frequency: 60Hz.
Power Rating: 204W
www.vaniman.com
Page 1
120V
sales@vaniman.com
10370-11/21 PAGE 1
Advertisement
Summary of Contents for Vaniman VMC-A450
- Page 1 PN: 10370 Dimensions: 37.8”L x 24.8”W x 20.3”H Weight: 70 lbs. Front View Voltage: 120V Amperage: 5A Frequency: 60Hz. Power Rating: 204W 20.3 37.8 25799 Jefferson Ave. Murrieta, CA 92562 1-800-VANIMAN (826-4626) www.vaniman.com sales@vaniman.com 10370-11/21 PAGE 1...
-
Page 2: Packing List
(see Figure A on next page). For example: If the desired position is near a corner using the wall mount, simply leave off the skirt parts from the back and adjacent wall side. To install the hood skirt parts: 25799 Jefferson Ave. Murrieta, CA 92562 1-800-VANIMAN (826-4626) www.vaniman.com sales@vaniman.com ... - Page 3 Open the door. Put one screw through the existing hole on the left side beneath the filters. This must also screw into a wall stud to keep the Fume Hood from lifting off of bracket. (See figure B) 25799 Jefferson Ave. Murrieta, CA 92562 1-800-VANIMAN (826-4626) www.vaniman.com sales@vaniman.com ...
-
Page 4: Application Instructions
6. If you are using Vaniman’s Remote Switch accessory, P/N VMC-A450, test it with the Fume Hood by plugging it into the socket labeled Remote on the control panel on the top of the unit. Next, flip the On/Off/Remote switch on that same control panel to the Remote position. -
Page 5: Maintenance
Pull out the old Charcoal Odor filter from the unit. Remove the plastic packaging from the new filter before sliding into place. Either side of the filter may face up. Vaniman recommends to always have a spare, however, keep new unused filters wrapped in their plastic wrappers to ensure freshness until use. -
Page 6: Replacement Parts
#2 above. REPLACEMENT PARTS The following items are offered to enhance the usage of your quality Vaniman Unit. These items can be ordered through your supplier using the following part numbers. Please feel free to contact Vaniman Manufacturing Co. with questions regarding our products. - Page 7 1. WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a. Use this unit in the manner intended by Vaniman. If you have any question about the use of this product, please contact Vaniman directly.