Advertisement
Uni-P Vantix 950 AIR MOVERS
Housing Disassembly
Tel: 888-994-0895
Installation, Operation & Service Instructions
3
Uni-P Vantix 950 AIR MOVERS
Operating Instructions
Prior to use, verify that the power cord and plug are not broken.
NOTE:
Ensure the power switch is off, then unwrap the power cord and plug it into a standard 115V
GFCl-protected outlet.
Point the air outlet towards the area that needs to be dried.
Press the Up or Down button to adjust the airflow speed on the panel.
Once the surface is dry, turn the unit off and unplug the power cord.
Wrap the power cord around the machine in a clockwise direction and secure with a clip.
Use the handle to move the machine to the next drying area or to storage.
The units may be stacked for transportion or storage
Always keep the units dry.
NOTE:
Citcuit Breaker Reset
The Unip Vantix 950 is equipped with a Circuit Breaker Reset Switch to protect from fire or
shock risk. The Circuit Breaker switch will:
Automatically cut off power to the machine if the circuit is overloaded
Automatically cut off power to the machine if it finds a ground fault
If reset switch is flipped, complete the following steps:
Check the power line for any damage and ensure it is properly connected to a grounded outlet
Press the Circuit Breaker Reset Switch to restart the unit
Maintenance
Cleaning the Housing & Impeller
If dust or dirt has accumulated on the impeller, you will need to disassemble the housing
(see instructions on next page) to clean it. Do not use liquids to clean the impeller- only a
cloth on pressurized air. The housing can be cleaned with a damp, cloth but always ensure it
is dry prior to reassembling.
4
Installation, Operation & Service Instructions
Tel: 888-994-0895
Advertisement
