Page 2
(1). Check all of the parts Taper screw X 32 Aluminum rod : Flat screw X 4 38.5 cm X 2 Plastic pad X 4 25.5 cm X 2 L-shape block X 16 19 cm X 2 Straight washer X 34 16 cm X 2 Black straight washer X 2 Aluminum base plate X 1...
Page 3
(2). Recognize the parts. (3). Start the base assembly. Plastic pad with flat screw Insert 2 straight washer Taper screw L-shale block Black straight washer 19 cm aluminum rod Straight washer...
Page 4
(4). Combination base parts. (5). Finish the base assembly. 19 cm aluminum rod 25.5 cm aluminum rod L-shape block with straight washer with taper screw X 4 sets.
Page 5
(6). For prevent scrap, pre-installed the plastic pad on the holder’s base. Plastic pad with flat screw Installed on the holder’s base with straight washer X 4 sets...
Page 6
(7). Start to assembly the hanger part Insert all the 8 screw sets into the 19 cm aluminum rod 19 cm aluminum rod L-shape block with straight 16 cm aluminum rod washer with taper screw X 8 sets...
Page 7
(8). Assembly the hanger part with main aluminum rod Note : this step must be decided the hanger screw height for fit your robots Finish assembly hanger Main aluminum rod 38.5 cm X 2 with main aluminum rod...
Page 8
(9). Connection base part with main aluminum rod L-shape block with black 38.5 cm Main Base part straight washer with taper aluminum rod screw X 2 sets...
Page 9
(10). Finish the holder frame assembly Front side view Back side view Right side view Left side view...
Page 10
(11). Install the aluminum base plate Install the aluminum base plate Remove the 4 plastic pad and and then re-screw the plastic pad flat screw sets and flat screws...
Page 11
(12). Finish the robot holder assembly Front side view Back side view Right side view Left side view...
Page 12
Adjust the hanger for fit your robot height...
Page 13
THE END ! Hoping you have a funny time on Robot’s world !!! Thank you for purchased RCmart products ! RCmart International, Inc. http://www.rcmart.com.tw...
Need help?
Do you have a question about the Robot Holder and is the answer not in the manual?
Questions and answers