Sony BZDM-7020 User Manual page 26

Setting Up the GPI Inputs – 704
10-14
Chapter 10 Setup Operations
Low Active: When the GPI input is low level, switch to the
operating mode specified as "ACTION". Effective only
when "ACTION" is "4:3", "16:9", "525", or "625".
Off: No operation.
3
Press F2 (ACTION PREVIUS) or F3 (ACTION NEXT) to
select the trigger action.
Pressing F3 (ACTION NEXT) cycles forward through the
possibilities under the heading "ACTION LIST" on the right,
and pressing F2 (ACTION PREVIUS) cycles through in the
reverse sequence.
NOP: Ignore incoming GPI signals.
Recall EFF #: Recall a key frame effect.
Run: Execute a key frame effect.
Stop: Stop a key frame effect.
Rewind: Rewind a key frame effect.
Freeze: Freeze the input signal to the DME-3000.
Fwd jitter: Each time the GPI signal is input, move forward
one frame, and jitter, that is, display fields 1 and 2
alternately.
Rewind jitter: Rewind key frame effect, and jitter, that is,
display fields 1 and 2 alternately.
+1 Frame: Move a stopped key frame effect forward by one
frame.
–1 Frame: Move a stopped key frame effect back by one
frame.
+1 Field: Move a stopped key field effect forward by one
field.
–1 Field: Move a stopped key field effect back by one field.
4:3: Select a screen aspect ratio of 4:3
16:9: Select a screen aspect ratio of 16:9
525: Set system operating mode to 525
625: Set system operating mode to 625
Snapshot #: Recall a snapshot.
4
If you selected "Recall EFF #" or "Snapshot #"in step 3, press
F4 (EFFECT NUMBER) or F5 (SNAPSHOT NUMBER), and
enter the number of the effect from the numeric keypad.
5
Repeat steps 1 to 4 as necessary to carry out the settings for all
of the input ports.