Nuvico Xcel NCT-5MLC-E2 Quick Start Manual

NCT-5MLC-E2 Eyeball Camera
Quick Start Guide
■ Please read these instructions carefully before operating the unit
and keep it for further reference.
■ All the examples and pictures used here are for reference only.
■ The contents of this manual are subject to change without notice.
■ Visit nuvico.com for additional downloads, manuals, and resources.
1
Warning and Caution
■ If the product does not work properly, please contact your dealer or the
nearest service center. Never attempt to disassemble the camera yourself.
(We shall not be responsible for any problems caused by unauthorized
repair or maintenance.)
■ Do not allow water or liquid intrusion into the camera.
■ In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the product is
mounted on wall or ceiling, the device shall be firmly fixed.
■ Do not use camera beyond specified voltage range.
■ Do not drop the camera or subject it to physical shock.
■ The product must be grounded to reduce the risk of electric shock.
■ Avoid touching the camera lens.
■ If cleaning is necessary, please use clean cloth to wipe it gently.
■ Avoid pointing the camera towards the sun or other light sources.
■ Do not place the camera in extremely hot, cold (the operating
temperature shall be -22˚F~140˚F), dusty or damp locations, and do not
expose it to high electromagnetic radiation.
■ To avoid heat accumulation, good ventilation is required for operating
environment.
2
Package
Camera Quick start guide
Allen key
Drill template
3
Overview
1
2
3
4
5
6
1
5
Ethernet connector
Audio input
2
6
3 Power connector
7
4
Mounting base 8
DC12V
* 1 It is recommended to install the security cap for outdoor installation.
* 2 If the PoE switch is used to power the camera, DC12V power supply is not
required.
4
Installation
Before you start, please make sure that the wall or ceiling is strong
enough to withstand three times the weight of the camera. Please
Tapping screws × 3
install the camera in a dry environment.
① Loosen the fixed screw to disassemble the camera.
×3
Plastic plug
② Unscrew the cover of the dome and then insert a micro SD card.
After that, install back the cover and make sure the cover is installed
firmly.
7
Cover
8
③ Drill the screw holes and the cable hole on the ceiling according
to the drill template. Then route and connect the cables.
Fixed screw
Microphone
Micro SD card slot
Reset
Fixed Screw
Mounting Base
Enclosure
Dome
Insert a micro SD card
(mm)
Ø91.9
Ø63.8
Ø4.5
Earth wire connection