Safety Warnings and Precautions WARNING: When using tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. 1. Keep work area clean. Cluttered areas invite injuries. 2. Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain.
Page 3
Product specific safety precautions This equipment is designed be operated by qualified personnel. It should only be operated after reading and understanding the safety warnings and operating procedures in this instruction manual. 1. Do not smoke near this equipment. 2. Firework is strictly prohibited during operation, keep away from heat, high voltage, flammable and explosive place 3.
Page 4
Product description: 1. Fast vacuum speed, capable of high negative pressure, multi-purpose equipment. 2. High quality cylinder, higher intensity, high grade of transparency as well as high temperature resistance (able to withstand 80℃ & negative pressure without deforming). Transparent cylinder allows oil observation and measurement.
Page 5
Package Contents Please inspect and look for damages from shipping when package is first received. If the unit is damaged in any way, please contact customer service and include pictures if possible. In the package, you will find: One Complete Oil Tank/Reservoir One Complete Measuring Glass/Cylinder One Oil Collecting Bowl/tray One Strain...
Page 6
Cylinder Flat Flat head hexagonal screw Oil tank FIG.1 2) Preparation 1. Check well connected of all pipes. 2. Making sure all ball valves and switches are closed. 3. Stop the engine of the vehicle. 4. Temperature of oil in the engine should between 40~60℃. Start the vehicle for a while to heat the oil. 3) Vacuum Generation (Fig.2) Operating air pressure: 6~8 bar/87~116PSI Consumption of air: 150L/Min...
Page 7
Now it is ready for extraction Tips: ball Valve should be on the position off when only extract vacuum for the cylinder, in order to have a view of the quality and quantity of the waste oil. If extract to be vacuum for both measuring glass and tank 1.
Page 8
2. Insert the end of the probe into the engine oil inlet hole of the engine.(Fig.3) 3. Turn on the ball valve (Fig.01) 4. If waste oil only extracted into the cylinder. Please making sure the valve is closed. 5. If waste oil extracted to the oil tank through the cylinder. Please open the ball valve accordingly. Also the oil tank needs to be vacuum before extraction operation.
Page 9
Turn on valve ③ , if vacuum existed in the tank, and then oil from cylinder will be fast transferred into the tank. If no vacuum existed in the tank, turn on the ball valve (Fig.01) for helping making a quicker transferring of waste oil into the tank.
Page 10
1.0 bar/15.4PSI, turn off the air compressor immediately and quickly drop the tank pressure below 0.8bar/11.6PSI, otherwise it could lead to serious incident) WARNING!!! 1. The ball valve (Fig.1) must be closed in order to prevent air enter causing transparent measuring glass damaged.
Page 11
Pipe to pipe connection should be tightly closed together. It’s necessary to release the waste oil as soon as possible in case of the corroding of tank. If you work for suction oil for a long time (ordinary one year), please check the adapter of the probe for leakage.
Page 12
Cylinder Wing valve Locking ring Oil tank FIG.3 12...