Intermec Mini Landline Quick Start Manual
Intermec Mini Landline Quick Start Manual

Intermec Mini Landline Quick Start Manual

Mini landline 3.3 volt modem

Advertisement

Quick Start Guide

P/N 961-031-019
Revision A
December 2001
Mini Landline
3.3 volt Modem
P/N 961-031-019 Revision A
*961031019*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mini Landline and is the answer not in the manual?

Questions and answers

Summary of Contents for Intermec Mini Landline

  • Page 1: Quick Start Guide

    Quick Start Guide P/N 961-031-019 Revision A December 2001 Mini Landline 3.3 volt Modem P/N 961-031-019 Revision A *961031019*...
  • Page 2: Packing List

    Mini Landline Modem Quick Start Guide Packing List Check to ensure that you receive these items: Mini Landline Modem Data Communication Cable AC Power Supply (U.S. wallcharger shown)
  • Page 3: General Information

    Mini Landline Modem Quick Start Guide General Information This kit allows you to connect your Intermec Mobile Computer to any phone line for conducting dial--up communication sessions. Using this mini landline modem requires you to follow the connection instructions and install and enable the modem software in your mobile computer.
  • Page 4 Mini Landline Modem Quick Start Guide If your 700 mobile computer is " low on power, or if you are working with a 600 mobile computer, you need to use the external power supply. For connecting instructions refer " to the Power Supply to Modem Connections section in this guide.
  • Page 5 Mini Landline Modem Quick Start Guide Connections Power Supply to Modem The external power supply is for using your modem with a 600 mobile computer or if your 700 mobile computer is low on battery power. Shown below is the U.S. wallcharger type power supply.
  • Page 6 Mini Landline Modem Quick Start Guide Country Identification Country Identification Code 34 is the default standard which works for most countries. To change the country code, use the following modem command string: AT%T19,O,XX (XX= country identification code, shown below) For the countries listed change the AT command set to reflect the ID Code.

Table of Contents