Advertisement
Quick Links
GETTING SET UP
1
Place Mella on a flat, level surface, like a
countertop or tabletop and plug in the power supply.
3
Twist off cap from the side tank, fill with water, and
secure the cap back on the tank.
5
Follow the manufacturer's instructions for
preparation, then set fruiting blocks inside
chamber.
QUICK START
2
Slide the water tray into the unit through the
opening on the left-side wall.
4
Open the chamber door, slide the fan bracket up,
and place one (1) humidity filter inside the water tray.
Lower the fan bracket over the filter.
Make sure the
filter sits all the
way down into
the water tray with
felt facing forward.
6
Use the back side of this quick start guide to help
set the right environmental conditions.
Advertisement
Related Manuals for FirstBuild Mella
Summary of Contents for FirstBuild Mella
- Page 1 QUICK START GETTING SET UP Place Mella on a flat, level surface, like a Slide the water tray into the unit through the countertop or tabletop and plug in the power supply. opening on the left-side wall. Twist off cap from the side tank, fill with water, and Open the chamber door, slide the fan bracket up, secure the cap back on the tank.
- Page 2 Fresh air Starting point: Setting 4-6 Mella’s fan will automatically cycle on to bring fresh air into the chamber. This decreases the CO2 concentration that naturally rises as mushrooms grow. If your mushrooms have skinny stems or fruiting bodies, or their growth resembles coral, increase the fresh air.
Need help?
Do you have a question about the Mella and is the answer not in the manual?
Questions and answers