Download Print this page

Zen Habitats Cabinet Stand Assembly Instructions

Parts list:

Part A (2) – 46" Aluminum Frame (2 channels at 90-degree angle)

Part B (6) – 22" Aluminum Frame (2 channels at 90-degree angle)

Part C (2) – 22" Aluminum Side Door Frame (1 channel)

Part D (1) – 46" Aluminum Top Door Frame (1 channel and 1 double 3/4" top door rail)

Part E (1) – 46" Aluminum Bottom Door Frame (1 channel and 1 double 1/4" bottom door rail)

Part F (8) – Pressure corners (with 3 prongs)

Table of Contents

Do you have a question about the Cabinet Stand and is the answer not in the manual?

Page 1 Zen Habitats Cabinet Stand Assembly Instructions Parts list: Part A (2) – 46” Aluminum Frame (2 channels at 90-degree angle) Part B (6) – 22” Aluminum Frame (2 channels at 90-degree angle) Part C (2) – 22” Aluminum Side Door Frame (1 channel) Part D (1) –...
Page 2 Parts List Continued: Part I (1) – 4’x2’ Bamboo Lined Wood Back Panel Part J (1) – 4’x2’ Bamboo Lined Wood Bottom Panel Part K (2) – 2’x2’ Bamboo Lined Wood Side Panels Part L (2) – Bamboo Lined Wood Doors Part M (2) –...
Page 3 • Attach the other side frame, with the two pressure corners already connected, to the assembled frame. You should now have a rectangle shaped floor with four fingers facing up. Step 2 – Assemble Back and Sides • Attach the side door frame (Part C) to the pressure corners that align with the bottom door track. SPECIAL NOTE: Make sure the front side door frame’s channel is facing the back of the enclosure.
Page 4 • Insert the two side panels (Part K) on the left and right-side channels. Insert the back panel (Part I), with the grommet hole, in the back channel. Step 3 – Assemble Top • Attach the pressure corners to each end of two 22” aluminum frames (Part B). Make sure that the fingers from the corners align with the channels of the frame.
Page 5 Step 5 – Support Bars (Optional) • If you plan on using substrate over 100 lbs., but less than 250 lbs, use the support bars provided. Simply place on top of the cabinet stand.