Advertisement
1
Assembling the Body of Santa and the Front Half of the
Motorcycle
Place all the parts flat on the ground or table. Insert the connecting rods on
the bottom of the Top Section of Santa's Body (A) into the matching
connecting holes on the top of the Bottom Section of Santa's Body and Back
Half of the Motorcycle (B) and fasten at the connecting loops with Plastic Tie
(F). Insert the connecting rods on the bottom of Santa's hand into the
matching connecting holes of Motorcycle handle. Insert the connecting rods
of Motorcycle Body into the connecting holes on Santa's Leg and fasten at
the connecting loops with plastic Tie (F). Hint: With extra Plastic Ties,
secure the parts over the metal frames at various locations where they
adjoin.
3 Assembling the Power Plug
Connect the power cord plugs together and secure with the built-in cap
screw.
ASSEMBLY
A
F
B
2
Assembling the Base Stand and Support Bar
Insert the connecting rods on the top of Base Stand (D) into the matching
connecting holes on the bottom of the back wheel and the underside of the
Motorcycle then fasten at the connecting loops with Plastic Tie (F). Insert each
hooked end of the Support Bar (E) into the matching connecting holes on the
top of Arm and the Base Stand (D) then secure with the Cotter Pins (G).
E
4 Assembling the Ground Stakes
Place the 4 Ground Stakes (H) over the 4 Corners of the Base Stand and the
Front Wheel then firmly into the ground.
H
G
F
D
Advertisement
