Rugged Computing CONNECT BT2 User Manual

RUGGED CONNECT BT2
USER GUIDE
POWER ON
Long-press ( ) for 3 seconds to
power on.
POWER OFF
Quick-press ( ) and (--) at the same
time.
ANSWER PHONE CALL
When you have an incoming phone
call, quick-press ( ) to answer the
call.
REJECT PHONE CALL
When you have an incoming phone
call, long-press ( ) for 1 second to
reject the call.
END PHONE CALL
While on a phone call, quick-press
( ) to end the call.
ACTIVATE VOICE COMMANDS
To activate voice commands on your
phone quick-press (--) and (+) at the
same time.
with our rider to rider communications kit
•Connect unlimited riders
•Talk for miles
•Scan to learn more!
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna, increase the separation between the equipment and receiver,
connect the equipment into an outlet on a circuit different from that to which the receiver is connected, consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of
the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
RUGGED CONNECT BT2

BUTTON FUNCTIONS

PAIRING MODE
With BT2 off, long-press ( ) for 7
seconds. Pairing mode is indicated
by the light flashing red and blue. Go
to Bluetooth settings on your device,
search for "BT-MOTO" and follow
device pairing instructions. Once
paired, the light will slowly flash blue.
UP
While playing Bluetooth audio, quick-
press (+) to increase the volume.
VOLUME DOWN
While playing Bluetooth audio, quick-
press (--) to
Decrease the volume.
SKIP FORWARD
While playing Bluetooth audio, long-
press (+) to skip to the next track.
SKIP BACK
While playing Bluetooth audio, long-
press (--) to skip to the previous
track.
PLAY AND PAUSE
While playing Bluetooth audio, quick-
press ( ) to play and pause audio.
ruggedradios.com/bt2-upgrades
USER GUIDE | VERSION 1.0.1 | MAY 2022