Jabra 14201-20 How To Connect

Hide thumbs Also See for 14201-20:

Jabra Link 14201-20

How to connect my Jabra GN9120 EHS / GN9125 EHS with

Avaya IP 2410, IP 5410, IP 6416D, IP 6416M, 6424D, 6424M

Prerequisite:

Jabra GN9120 EHS + Jabra LINK 14201-20

Jabra GN9125 EHS + Jabra LINK 14201-20

In combination with one of the following Avaya phones:

IP 2410

IP 5410

IP 6416D+M/ 6424D+M

1. Insert the RJ9 to RJ9 connection cable supplied with the GN912x into

the socket marked with the "phone" on your GN912x base and the

other end into the socket marked with the "phone" symbol on the EHS

adapter.

2. Now connect the end of the RJ45 to RJ45 connection cable (EHS

adapter) marked in "red" to the socket marked "AUX" on the EHS

adapter as well as with the "AUX" socket on your GN912x base.

3. Now connect the RJ9 to RJ9 connection cable marked white "A" to the

socket marked "headset/handset" on the EHS adapter as well as with

the "headset" socket on your phone.

4. Important: with the 6416D+M / 6424D+M phones, the cable marked

with white "B" must be used instead of the ("C" cable).

5. Connect the dial tone sensor to the EHS adapter and attach this to the

middle of the phone speaker.

https://www.jabra.in/supportpages/jabra-link-14201-20/14201-20/faq/fff7d129-9c8c-4eb8-

adcd-bc21a6f34e35

11/08/2022 06:23

Page 1 of 3

Table of Contents

Do you have a question about the 14201-20 and is the answer not in the manual?

Page 1 11/08/2022 06:23 Jabra Link 14201-20 How to connect my Jabra GN9120 EHS / GN9125 EHS with Avaya IP 2410, IP 5410, IP 6416D, IP 6416M, 6424D, 6424M Prerequisite: Jabra GN9120 EHS + Jabra LINK 14201-20 Jabra GN9125 EHS + Jabra LINK 14201-20...
Page 2 11/08/2022 06:23 EHS setup: The Jabra GN912x must be set up on DHSG EHS. (The Jabra GN9120 DHSG is always supplied in DHSG mode). You can check or set it as follows. 1. Place the headset in the base. 2. Then press the PLUS and MINUS buttons simultaneously for 6 seconds until the online display on the headset starts to flash.
Page 3 3. You can now increase the volume with PLUS or decrease the volume with MINUS. 4. To confirm, after approx. 10 seconds a low signal tone sounds in the headset in the background. The settings are then saved. https://www.jabra.in/supportpages/jabra-link-14201-20/14201-20/faq/fff7d129-9c8c-4eb8- Page 3 of 3 adcd-bc21a6f34e35...