Page 1
INSTRUCTION MANUAL 24” HD LED TV SQ240W AIR/CABLE MODE SELECTION The Air/Cable menu option is set to the “Air” mode at the factory so that you can receive the over-the-air broadcast signal. If you want to receive the Cable TV signal through the antenna input terminal, this menu option must be switch to the “Cable”...
Introduction Thank you for purchasing QUASAR HD LED Television. To get the most out of your new purchase, it is highly recommended that you read this manual before starting the operation. INSTALLATION Locate the receiver in the room where direct light does not strike the screen.
Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL . This symbol is intended to alert the user to avoid the risk of electric shock.
Caution Caution High voltages are used in the operation of this product. Do not open the product's casing. Refer servicing to qualified service personnel . Caution To prevent fire or electrical shock hazard, do not expose the main unit to rain or moisture do not place objects filled with liquids, such as vases, on the apparatus.
Page 6
Caution Caution Never stand on, lean on or suddenly push the product or its stand. You should pay special attention to children. Caution Do not place the main unit on an unstable cart stand, shelf or table. Serious injury to an individual and damage to the television may result if it should fall.
Main unit description Control Panel Button Function VOL+ : Volume up. VOL- : Volume down. CH+ : TV channel up. CH- : TV channel down. MENU : Press to select the main menu. SOURCE : Select the input sources. POWER : Switching Power On/Standby. TV Terminal Connections 1.
Remote control POWER: Power on/off button, press once to turn the TV on and press again to turn the TV off. MUTE: Press this button to mute or restore sound. In the TV condition, press this key to select the stereo mode. MTS: ASPECT: Press to adjust picture ratio.
Page 9
Instruction for Wall Mount Quasar 100mm x 200mm Quasar...
Page 10
Installation Guide Press MENU button to display the MAIN OSD MENU; Press button to select the MENU you want; Press ENTER button to enter the sub menu; Press button to select the option and then press to adjust the value in the sub menu; You can press MENU button to go back to the upper menu or EXIT button to close the OSD.
Page 11
“Aspect Ratio” and press the “ / ” button to select. Press “ / ” button to select “Noise Reduction” and press the “ / ” button to select. Press “ / ” button to select “Dynamic Contrast” and press the “ / ” button to select “On” or “Off”.
Page 12
4. Press “ / ” button to select “Time Format” and press the “ / ” button to select “12-hour” or “24-hour”. Press “ / ” button to select “Auto Clock” and press the “ / ” button to select “On” or “Off”.
Page 13
(e). Press “ / ” button to select “Font Edge Color” the “ / ” button to adjust. (f). Press “ / ” button to select “FG Color” the “ / ” button to adjust. (g). Press “ / ” button to select “BG Color” the “ / ” button to adjust. (h).
Page 14
select time zone. d. Press “ / ” button to select “Daylight Saving Time” and press the “ / ” button to select “On” or “Off”. e. Press “ / ” button to select “Time Format” and press the “ / ” button to select “12-hour”...
Page 15
“ENTER/ ” Password”, then press button to adjust the value. If the password is changed, all of the passwords in the menu will be changed at the same time. Note : If you forget your password, you can use “1470” to enter any menu locked. Press “...
Page 16
5. Press “ / ” button to select “US Rating” and press “ENTER/ ” button to enter sub-menu. a. Press “ / ” button to select “TV” and press “ENTER/ ” button to enter sub-menu. Press “ / ” button to select and press ENTER to block or unblock.
Page 17
PC Setting Press the “MENU” button to enter the OSD menu .Then press “e/f” button to select the “Setup” menu. And then press “d” button to select “PC Setting” and press the ENTER/f “ ” button to enter sub-menu. 1. Press “c/d” button to select “H-Pos” and press the “ ”...
SPECIFICATIONS SQ240W Viewing Picture Size(diagonal) 23.6 inches Resolution 1366x768 Aspect Ratio: 16:9 TV System: ATSC Digital system and NTSC Analog system Video Signal System: NTSC Receiving Channel: Cable :1-135/ Air: 2-69(ATV&DTV) Maximum Power Consumption: Input Power Voltage: AC 100-240V Audio Output Power(THD...
Need help?
Do you have a question about the SQ240W and is the answer not in the manual?
Questions and answers