Talkaphone WEBS-PM Installation Instructions

I. Introduction
WEBS-PM Pedestal Mount Emergency Phone Station with WEBS
foundation using anchor bolts.
II. Contents
Before beginning installation, make sure you have all the included components. Each Pedestal consists
of three packages. Package #1 is the labeled WEBS-PM-KIT. Package #2 is labeled ETP-PM PARTS.
Package #3 contains the Pedestal itself.
WEBS-PM-KIT
Qty. Part Number
1 68642
1 86396
2 83075
ETP-PM PARTS
Qty. Part Number
4 42838
8 42839
8 42840
3 42867
2 42843
1 68590
1 67478
1 24717
III. Installation
1. Electrical and telephone line conduits should be run through the foundation and into the center 4"
diameter hole of the Pedestal.
NOTE: To insure proper grounding of all electrical components, the tower mount should be effectively earth grounded
from the grounding stud (located across from the lower access panel) with 6 AWG or better insulated, stranded copper
wire to the metallic power service raceway (conduit) or an 8 foot or longer corrosion-resistant ground spike. It is the
installer's obligation to ensure compliance with all national, regional, and local regulations
2. Pour the foundation at least 2-feet in diameter and 3-feet deep according to your local code and frost
line.
3. Install the four (4) 3/4" - 10 x 24" long anchor bolts below grade with five inches (5") projecting
above grade. Use the template provided to properly position the bolts within the concrete
foundation.
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
WEBS-PM – Pedestal Mount
Emergency Phone Station with WEBS
Description
2-Channel Amplifier
Power Supply (12VDC, 5A)
Loudspeaker
Description
J-Bolts
3/4"-10 Hex Nut
3/4" Washer
10-24 x 1/2" Tamper Resistant Screws
6-32 Hex Nut
LED Panel Light (12-24VAC/DC, 120VAC)
Polycarbonate Cover for LED Panel Light
Pedestal Mount Aluminum Template
Installation Instructions
®
is designed to mount to concrete
.
®
Rev. 4/7/2014