Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for CommScope FACT-1ESPLA04
- Page 1 FAC T Splice Drawer INSTALLATION INSTRUCTION...
-
Page 2: Table Of Contents
Do not assume the laser power is turned off or that the fiber is disconnected at the other end. Kit content FACT Splice Chassis (as ordered) Bracket Kit (according to chassis-configuration) Page 2 of 12 860656985 © 2020 CommScope, Inc. All Rights Reserved Rev. A... -
Page 3: Mounting Fact Chassis In Rack
Prepare the rack with the brackets on the position where you want to install the FACT Chassis (by sliding them in). Step 2: Align the FACT Chassis with the brackets on both sides. Page 3 of 12 © 2020 CommScope, Inc. All Rights Reserved... - Page 4 4. Mounting FACT Chassis in Rack Step 3: Slide the FACT Chassis into the brackets until you hear a “clicking noise”.. Page 4 of 12 © 2020 CommScope, Inc. All Rights Reserved...
-
Page 5: Dismounting Fact Chassis
5. Dismounting FACT Chassis Step 1: Open the upper drawer (releasable). This one is marked at the front (blue marking at the bend control). Page 5 of 12 © 2020 CommScope, Inc. All Rights Reserved... - Page 6 Pull the blue puller locks (make sure both sides are in the unlocked position). Step 3: Slowly slide the FACT Chassis out (pull simultaneously on both sides, with both hands). Page 6 of 12 © 2020 CommScope, Inc. All Rights Reserved...
-
Page 7: Opening The Cover
Apply some force (pinching together in the direction of the arrows) to unlock the cover. Rotate the cover upwards to open it. Step 2: The cover will stay in the open position if this is rotated about 85°. Page 7 of 12 © 2020 CommScope, Inc. All Rights Reserved... -
Page 8: Removing The Cover
Pull the cover in the 10° angle towards the front. The cover will pop out of the hinge. To re-assemble the cover, repeat the 2 previous steps the other way around. Page 8 of 12 © 2020 CommScope, Inc. All Rights Reserved... -
Page 9: Handling The Label
Notes can be made on the label when the cover is closed (this acts as a support). The label can also be removed if preferred. It is held in place in the four corners. Simply slide it out of the four corners to remove. Page 9 of 12 © 2020 CommScope, Inc. All Rights Reserved... -
Page 10: Handling The Fiber Picker
The fiber picker is located on the left or right (as indicated by the arrows). To remove it, simply pull it upwards until it releases from the snapping features. Page 10 of 12 © 2020 CommScope, Inc. All Rights Reserved... - Page 11 Page 11 of 12 © 2020 CommScope, Inc. All Rights Reserved...
-
Page 12: Trade-Marks
10. Trade-marks: All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to CommScope products or services. CommScope is committed to the highest standards of business integrity and environmental sustainability, with a number of CommScope’s facilities across the globe...
Need help?
Do you have a question about the FACT-1ESPLA04 and is the answer not in the manual?
Questions and answers