Lagler 100.63.01.100 Operating Instructions / Safety Instructions

OPERATING INSTRUCTIONS / SAFETY INSTRUCTIONS
MAINTENANCE AND CARE
The work light contains no user-serviceable parts.
Check the work light regularly according to the legal require-
ments.
Defective LED work lights can not be repaired by the user and
must be disposed properly or repaired by the manufacturer.
TROUBLESHOOTING
Error description Possible causes
Power supply faulty
Work light does not light or
only with low power
Work light overheated
Work light flickers Power supply faulty
Circuit breaker trips
Too many work lights in a circuit
frequently
For errors not listed or for
faultless troubleshooting
GENERAL INFORMATION
Dispose of packaging material
For the packaging, environmentally friendly materials
have been selected that can be recycled for normal
recycling.
Make sure plastic sleeves, packaging, etc. are properly
disposed of.
Dispose of your old device
The crossed - out wheeled bin symbol on the work light
or its packaging indicates that the product and, if appli-
cable, the battery are at the end of their life cycle have
to be be disposed separately from the other waste.
www.laegler.com
Eugen Lägler GmbH
Kappelrain 2, D-74363 Güglingen-Frauenzimmern, Germany
Telephone: 0049 - (0) 7135 - 98 90-0, Telefax: 0049 - (0) 7135 - 98 90-98
E-mail: info@laegler.com, Internet: www.laegler.com
English
Replace defective components immediately and do not
operate damaged or defective work lights.
Always keep the work light clean.
Clean the work light regularly with a damp cloth.
Never use aggressive cleaning agents for cleaning.
Possible solutions
Check the supply lines and the power supply.
Wait until the work light has cooled down.
Check the installation requirements.
Clean the work light.
Check the supply lines and the power supply.
Reduce the number of work lights per circuit.
Check compliance with the installation and operating
guidelines.
Contact the manufacturer.
Do not just throw away these materials, make sure
they are recycled.
Observe the notes and markings on the packaging.
After the end of the life cycle, the user has to make
sure of a suitable waste disposal or hand it over to the
dealer for disposal.
OPERATING INSTRUCTIONS /
SAFETY INSTRUCTIONS
Work light 30 Watts
for HUMMEL
LÄGLER-Art.-Nr. 100.63.01.100
GENERAL INFORMATION
These operating instructions contain important information
on the safe operation of the work light. Read and follow the
safety instructions provided.
Keep the instructions for future reference. Make sure that it is
available to all persons who use the work light. Our products
INTENDED USE
This work light is used for lighting according to the specified
operating conditions. Any other use and use under other
operating conditions are considered improper and may result
®
D
IP65 IK08
are subject to a process of continuous development.
Therefore, changes remain reserved.
in personal injury or property damage. For damages arising
from improper use, no liability is assumed.