Table of Contents
Advertisement
Quick Links
GPS locator - GSM audio bug - HQ voice recorder
This 3in1 device is used for long-term HD recording of sound in the room or vehicle, audio surveillance with
the ability to call you when sound appears in the room or vehicle, and for GPS locating.
Voice recorder module setup
Battery life in recording mode is 75 hours, and in sleep mode 1800 hours (2,5 months). It
is equipped with the latest POWER SAVE technology, which allows it to go into "sleep" mode
while there are no conversations nearby and consume almost no battery.
Setting basic recording parameters using the built-in software:
Using the supplied USB cable, plug the device into a USB slot on any computer, the red light next to
the USB slot will turn on, and the batteries will begin to charge. Let the charging continue until the
red light starts blinking, indicating that the battery is full.
At the same time, the device will be recognized on the computer as an external drive marked
BURAN 500.
Open the folder, locate the setup.exe software, and open it:
C/ Duque de Sesto 13, 28009 Madrid
Email:
info@grupo-hispa.com
Teléfono: +34 911 369 092
BURAN 1200
1
Advertisement
Table of Contents
Summary of Contents for GH BURAN 1200
- Page 1 BURAN 1200 GPS locator - GSM audio bug - HQ voice recorder This 3in1 device is used for long-term HD recording of sound in the room or vehicle, audio surveillance with the ability to call you when sound appears in the room or vehicle, and for GPS locating.
- Page 2 Here you can change the parameters of the voice activation sensitivity, recording quality and synchronize the date and time on future recordings. In the left column (VOS sensitivity), select the activation sensitivity to sound. You can change it in 5 steps from very high to very low. The higher the sensitivity, the quieter the device will turn on, and vice versa.
- Page 3 does not come on at all when turned on, the battery is empty or almost empty, if it flashes and goes out, the battery is 30-70% full. Set the switch to the REC position for continuous recording and to the OFF position to turn off the unit.
- Page 4 CHARGING AND SWITCHING ON-OFF INSTRUCTIONS: Connect the device with the supplied coded cable to any USB charger and let the device charge until the red light on the USB slot stops blinking. (approx. 3-4 hours). Insert a NANO SIM card with a deactivated PIN into the SIM card slot. Pay attention to the direction of insertion of the card.
- Page 5 consumption mode. Only by activating this function battery can last for 7 days To turn on low power mode: Link#0 ACTIVATING ALARM FEATURES: This model has the ability to alert you if it senses sound or vibration in a controlled area. Activation and deactivation of this function is done by sending SMS messages of the following content.
- Page 6 You can only cancel the deep sleep command while the device is ON by sending: pwonoff#0,0,0#0,0,0 BURAN 1200 TECHNICAL SPECIFICATIONS : Battery: LiIon 1200mAh Voice activation with PC software for select activation voice level in 5 steps; ALC preamplifier for superior sound;...
Need help?
Do you have a question about the BURAN 1200 and is the answer not in the manual?
Questions and answers