Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lipper Oblo 1.0
Summary of Contents for Lipper Oblo 1.0
- Page 1 Oblo 1.0 Aluminum Blinds OEM INSTALLATION MANUAL...
- Page 2 Notes Introduction This document outlines the procedure to install and operate Oblo 1.0 aluminum blinds. NOTE: Images used in this document are for reference only when assembling, installing and/or operating this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
- Page 3 Resources Required • (6) #10 x 1/2" (3,5 x 13mm) screws • Cordless or electric drill or screw gun • Appropriate drive bits • 1-2 people depending on task Installation Center the Oblo aluminum blind over the window (Fig. 1). NOTE: Oblo aluminum blinds have custom sizing.
- Page 4 Operation Oblo Blinds have three different features: blind (Fig. 3A), screen (Fig. 3B) and latch (Fig. 3C). Grip the middle of the lower profile near the latch to raise the Oblo screen slowly and latch to the Oblo blind at the top (Fig. 4A). Grip the top screen and slowly pull down (Fig.
- Page 5 Notes Page 5 Rev: 09.08.22 CCD-0006415...
- Page 6 The contents of this manual are proprietary and copyright protected by Lippert. Lippert prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized Lippert representative has been provided. Any unauthorized use shall void any applicable warranty. The information contained in this manual is subject to change without notice and at the sole discretion of Lippert. ...
Need help?
Do you have a question about the Oblo 1.0 and is the answer not in the manual?
Questions and answers