Table of Contents
Advertisement
Quick Links
V
EMViewer
NFP Kit - Live Tracking Setup Guide
022022
Disclaimer
Warranty
The material contained in this user manual is provided "as is" and is subject to being changed,
without notice, in future editions. Further to the maximum extent permitted by applicable law,
YIC Technologies disclaims all warranties, either expressed or implied, with regard to this user
manual and any information contained herein, including but not limited to the implied
warranties of merchantability and fitness for a particular purpose. YIC Technologies shall not
be liable for errors or for incidental or consequential damages in connection with the furnishing,
use, or performance of this document or any information contained herein. Should YIC
Technologies and the user have a separate written agreement with warranty terms covering
the material in this document that conflict with these terms, the warranty terms in the separate
agreement shall control.
www.yictechnologies.com
Advertisement
Table of Contents
Summary of Contents for YIC Technologies EMViewer NFP Kit
- Page 1 Further to the maximum extent permitted by applicable law, YIC Technologies disclaims all warranties, either expressed or implied, with regard to this user manual and any information contained herein, including but not limited to the implied warranties of merchantability and fitness for a particular purpose.
- Page 2 Safety Notices Caution A CAUTION notice denotes a hazard. It calls attention to operating procedure, practice, or the like that, if not correctly performed or adhered to, could result in damage to the product or loss of important data. Do not proceed beyond a CAUTION notice until the indicated conditions are fully understood and met.
- Page 3 Installation and Hardware Setup 1. Install latest version of Keysight IO Click here to open the website to download the latest version. On the website click on the Download button and follow the steps. 2. Install the EMViewer Primum application Install the EMScanner software by clicking on the Setup application icon.
- Page 4 Taking Measurements The EMViewer software analyse the camera video stream and identify the probe type, position and its orientation based on the marker printed on the tip. For best performance, keep this marker visible to the camera. Correction can be turned on/off from the Open the EMViewer and add new node to the project.
- Page 5 Live Tracking is now active. Technical Support To help us provide fast and seamless technical support, kindly gather the following information, and contact Technical Support as instructed further below: 1. Make and serial number of your probe. 2. EMViewer software version 3.
Need help?
Do you have a question about the EMViewer NFP Kit and is the answer not in the manual?
Questions and answers