Thank you for purchasing this product For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. Surge protection device recommended This product contains sensitive electrical components that may be damaged by electrical spikes, surges, electric shock, lighting strikes, etc.
1. Introduction Paugge 18Gbps HDMI Extender can extend high definition video / audio signal, RS-232, bi-directional IR and internet signal, at the distance of up to 328ft / 100 meters between transmitter and receiver via a single CAT6a/7 cable and support resolution up to 4K2K@60Hz 4:4:4. The Transmitter supports ARC function and local audio extract.
3. Package Contents Item 18Gbps HDMI over HDBaseT Extender (Transmitter) 18Gbps HDMI over HDBaseT Extender (Receiver) IR Blaster cable (1.5 meters) 20~60KHz IR Receiver cable (1.5 meters) Mounting Ear 3-pin Phoenix connector 24V/1A Locking Power adapter User Manual 4. Specifications Technical HDCP Compliance HDCP 2.2 / HDCP 1.4...
Page 5
Connection Inputs: 1x HDMI Type A [19-pin female] Outputs: 1x HDBT OUT [RJ45, 8-pin female] 1x SPDIF OUT [S/PDIF] 1×L/R OUT [3.5mm Stereo Mini-jack] 1×LAN [RJ45] Transmitter Control: 1x IR IN [3.5mm Stereo Mini-jack] 1x IR OUT [3.5mm Stereo Mini-jack] 1x RS-232 [Phoenix jack] 1x SERVICE [Mini-USB, Update port] 1×USB HOST [USB Type B ]...
▪ Illuminate: Transmitter and Receiver are in good connection Connection Signal status. Indicator lamp ▪ Flash: Transmitter and Receiver are in poor connection (on the left side of the status. HDBT OUT port) ▪ Dark: Transmitter and Receiver are not connected. Data Signal ▪...
Page 8
Green LED is on when SPDIF OUT port outputs the the SPIDIF LED audio signal returned from SPDIF IN on the Receiver. Two USB 2.0 ports Connect to USB device. Press the button to switch the output audio signal source for SWITCH SPDIF OUT and L/R OUT port.
5.3 Audio Signal Output Switching Switch the output audio signal source for SPDIF OUT and L/R OUT port via the “SWITCH” button on the panel (the corresponding LED will illuminate). The states of ARC LED and SPDIF LED indicate the audio output logic, as shown in the table below: ARC LED SPDIF LED...
6. Application Example SERVICE ARC SPDIF SWITCH USB HOST Transmitter TX RX DC 24V HDBT OUT HDMI I N IR IN IR OUT L/R OUT SPDIF OUT RS-232 LA N Audio Amplifier Router HDMI Matrix with DVD or Blu-ray Player IR Blaster RS-232 function Power Supply...