Advertisement
5
安装底座
Mounting Base
取安装底座小端靠墙，在安装脚轮廓圈内用铅笔或记号笔画出安装孔轮廓。
注意：请按图将螺丝孔位错位摆放。
Take the small end of the mounting base against the wall, and draw the
outline of the mounting hole with a pencil or a marker inside the contour
circle of the mounting foot.
Note: Please install the plug hole in dislocation as shown in the figure.
7
Plastic Expansion
自攻螺钉
Self-tapping Screw
中央圆孔
（朝右安装）
Central Round Hole
(Install to the right)
在孔内打入塑料膨胀管，用自攻螺钉将底座上紧并固定在墙上。
注意：要将中间带圆孔的底座安装在右侧与PVC管穿线孔重合，请按图
将螺丝孔位错位摆放。
Drive a plastic expansion tube into the hole, tighten the base with self-
tapping screws and fix it on the wall.
Note: To install the base with a round hole in the middle to coincide with
the PVC pipe threading hole, please place the screw holes in a misplaced
position according to the picture.
塑料膨胀管
Undercounter Installation
Undercounter Installation
6
在画出的轮廓处钻直径8mm，深45mm的安装孔，并打入塑料膨胀管。
Drill a mounting hole with a diameter of 8mm and a depth of 45mm at the
drawn outline, and drive into the plastic expansion tube.
8
将电源线通过底座圆孔穿入PVC穿线管并到达预埋开关盒，后使用紧定螺
钉将产品安装在底座上，并上紧。
Pass the power cord through the round hole of he base into the PVC
conduit and reach the embedded switch box, then use the set screw to
install the product on the base and tighten it.
5
INS10634C - 11/18
8
电源线通到
开关面板处
The power cord
goes to the
switch panel
紧定螺钉
Set Screw
Advertisement
