Table of Contents
Advertisement
Quick Links
Operating Instruction and safety manual
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Health defects resulting from vibration emission if the power tool is being used over longer period of time or
not adequately managed and properly maintained.
4.
Wear eye protection.
1
Air Drill 17111
3/8" Air Straight Drill
Model : 17111
IMPORTANT:
Upon receipt of the product,
read and follow all safety rules,
operating instructions before first use it.
And retain this manual for future reference.
2013
2014
Advertisement
Table of Contents
Related Manuals for Aeropro 17111
Summary of Contents for Aeropro 17111
- Page 1 Operating Instruction and safety manual 3/8” Air Straight Drill Model : 17111 IMPORTANT: Upon receipt of the product, read and follow all safety rules, operating instructions before first use it. And retain this manual for future reference. Residual risks Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool’s construction and design:...
- Page 2 ISO 11148 are legibly marked on the tool. The employer/user shall contact the manufacturer to obtain replacement marking labels when necessary. Projectile hazards -Be aware that the failure of the workpiece, or accessories, or even of the inserted tool itself can generate Air Drill 17111...
- Page 3 -Use only sizes and types of accessories and consumables that are recommended by the drill or tapper manufacturer. -Avoid direct contact with the inserted tool during and after use, as it can be hot or sharp. Air Drill 17111...
- Page 4 -Wear warm clothing when working in cold conditions and keep your hands warm and dry. -If you experience numbness, tingling, pain or whitening of the skin in your fingers or hands, stop using the drill or tapper, tell your employer and consult a physician. Air Drill 17111...
- Page 5 The tool should be run for approximately 30 seconds to ensure oil has been evenly distributed throughout the tool. The tool should be stored in a clean and dry Air Drill 17111...
- Page 6 Grit or gum deposits in the wrench may also reduce performance. If your model has an air strainer (located in the area of the air inlet), remove the strainer and clean it. 5. When not in use, disconnect from air supply, clean tool and store in a safe, dry, childproof location. Air Drill 17111...
- Page 7 ■ Disconnect supply. Free motor by rotating drive shank manually where applicable ■ „O‟ rings throttle valve ■ Replace „O‟ ring . Tool will not shut off dislodged from seat inlet valve. Note: Repairs should be carried out by a qualified person. Air Drill 17111...
- Page 8 Bearing6201Z O-ring Trigger Rotor Connector 4.8*1.6 O-ring 5.6*2 Spring Blade Washer Drill 3/8” Compressed Fixed washer Bearing spring block Adjustable Rolling Steel Bolt M5*16 BallΦ2 button 2*18 O-ring 7*2 Rubber ring Gear O-ring 12*3 Bearing Idle gear Air Drill 17111...
Need help?
Do you have a question about the 17111 and is the answer not in the manual?
Questions and answers