Page 1
Failure to do so could result in fire, electric WARNING shock, or serious personal injury. 9733 Topanga Canyon Blvd. APT310, Chatsworth, CA 91311 Phone: 213-4467172 or 661-4358826 CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: ETL...
IMPORTANT SAFETY INSTRUCTION WARNING These instructions should be carefully retained and read before installation by the user. The booklet must be kept and delivered to the new user in case of disposal of the heater. The manufacturer reserves the right to vary the features of the product without prior notice.
Page 5
18. Do not use the appliance outdoors. 19. Never place the appliance where it may fall into a bathtub or other water container. 20. Do not run cord under carpeting. Do not cover the cord with throw rugs, runners, etc. Arrange the cord away from cluttered areas to avoid a tripping hazard.
HEAT VENTS(DON’T COVER) LISTING APPROVAL This appliance has been tested in accordance with the ETL Standards Model Number ZBI-15SRLT/M13 for fixed and location dedicated electric room appliances in the United Recessed or States and Canada. If you need assistance during installation, please...
2.0 ELECTRICAL INSTALLATION NOTES 2.1 GENERAL INSTRUCTIONS CAUTION - Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. A. Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the outlet are B.
3.0 INSTALLATION INSTRUCTIONS 3.1 UNPACKING AND TESTING APPLIANCE WALL Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance operates properly by plugging the power supply cord into a conveniently located 120 volts grounded outlet. 3.2 GROUNDING APPLIANCE This appliance is for use at 120 volts.
4.0 OPERATING INSTRUCTIONS Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate. 4.1 CONTROL PANEL BUTTONS The control panel buttons are located on the right of the fireplace as illustrated. Press the indicator to turn on the appliance, and press the other side to turn it off.
Page 11
To activate or deactivate all the functions including all lighting types POWER and heating modes. To activate or deactivate the flame. FLAME To adjust the brightness of flame (5 different light variants DIMMER adjustable) When the HEAT is on, the CANDLE/CHARCOAL light illuminates constantly and cannot be turned off.
4.3 REMOTE CONTROL Move the battery's transparent insulating piece away before using. Battery must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling advice in your area. 5.0 TROUBLESHOOTING GUIDE PROBLEM SOLUTION 1. The POWER button on the Turn on the POWER button on the remote.
Page 13
1. Heater switches are on, but Turn on the flame power switch. Flame power switch is not on. Heater is on, but no 2. Flame Adjusting knob is at low flame or low flame Turn the knob to the maximum setting. setting.
Make sure the battery is properly installed. Move the 1. The battery is not properly battery's transparent insulating piece away before installed. using. Aim the remote control at the receiver (middle of the 2. Not pointing to the right position. The remote control fireplace).
6.1 PARTIALLY REFLECTIVE GLASS CLEANING The partially reflective glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the partially reflective glass may collect dust particles; these can be removed by dusting lightly with a clean, dry cloth.
Page 16
Read and understand all assembly and operating instructions, all safety information, and warnings before use. The following will void this warranty: Damage caused from tampering with, modifying, or altering the fireplace insert in any manner; Damage due to incorrect assembly, improper care, misuse, or abuse; Damage from being used with the wrong power source;...