Page 1
J2840 Pet Carrier Trailer Assembly Instructions No tools needed! Adjustable wrench optional, but not required. Parts Included: (2) – Inflatable Tires/Wheel Assembly 57-305 (16x2.125) (1) – Frame Assembly Pieces w/ Attached Enclosure (1) – Safety Flag (1) – Hitch Attachment (1) –...
Page 2
J2840 Pet Carrier Trailer Assembly Instructions 4. On the underside of the trailer, press the blue button near the end of the axle tube. Allow the axle on the wheel to slide down into the axle tube. Release the blue button. Gently pull up on the wheel to ensure it is mounted in the axle tube fully.
Page 3
J2840 Pet Carrier Trailer Assembly Instructions 8. Slide the hitch receiver (Ball Bitch) into the tube on the back of your scooter. Insert the larger Clevis pin to keep it from pulling out. 9. Remove the smaller Clevis pin from the receiver. Adjust the height according to your preference.
Page 4
J2840 Pet Carrier Trailer Assembly Instructions 10.On the ball hitch, there is an eye screw. Loosen this screw until the ball clamp tips back. It is spring loaded so you will have to hold it back with your thumb. Place the cup portion of the hitch onto the ball.
Page 5
J2840 Pet Carrier Trailer Assembly Instructions 12.At this time, the pet trailer is fully assembled, attached to your scooter and ready for use. 5 of 5...