Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Haicen PACK-LFP-HC48100
- Page 1 BATTERY PACK-LFP-HC48100 Preface...
- Page 2 Thank you so much for buying lithium batteries from HAICEN Be sure to finish reading before installation / use; So you can use the lithium pack properly. After reading it, please keep it safe! If there is any ambiguity about this specification, or if you need to discuss...
-
Page 3: General Information
1. General Information This specification defines the performance of rechargeable LiFePO4 battery pack HC48100 manufactured by HAICEN. describes the type, performance, technical characteristics, installation, warning and caution of the battery pack. 2. Dimensions 3.Battery Specification（@ 25±5℃） Items Characteristics Normal capacity... -
Page 4: Battery Performance
environment Recommend 15～30℃、45～75%RH environment 4. Battery Performance Testing Conditions: Ambient Temperature: 25±5℃; Huminity:45%~85%. Normal charge: Charge battery under CC(0.2C)/CV(57.6V) mode until over charge protection or the charge current reduce to 0.02C, and then rest for 0.5h. Items Criterion Condition After Normal charge，discharge @0.2C current to the end Cycle life ≥3000cycles Of discharge voltage. - Page 5 Over-charge release method Under the release voltage Over-discharge warning for each cell 2.90±0.05V Over Over-discharge protection each cell 2.50±0.05V discharge Over-discharge release for each cell 2.80±0.10V Charge over current warning 105±3A 110A±3A，delay time 5s Charge over current protection Charge over current release Discharge or auto release Over current Discharge over current warning...
-
Page 6: Communication Function
5.5Communication Function RS485 Communication Battery modules mutually communicate through this RJ45 Pin Number Pin definition connector. 3、6 2、7 RS485-A 1、8 RS485-B 4、5 CAN Communication Battery modules mutually communicate through this RJ45 connector. Pin Number Pin definition CANH CANL 5.6 LED INSTRUCTION 5.61 LED Sequence ALARM 5.62 Capacity indication... -
Page 7: Led Display Function
5.63 Flashing description Flashing mode Flashing 0.25s 3.75s Flashing 0.5s 0.5s Flashing 0.5s 1.5s 5.64 LED Display Function system operating State state state Shut Dormancy Total blackout down According to the quantity Standby Normality Stand by indicator According to the quantity Normality indicator Over current... - Page 8 6.1 Packing list, rack set (optional) Serial Application Drawing QUANTITY number Description 1PCS Multiple+ Multiple- 1PCS Parallel 1PCS communication Supporting 4PCS structure M8*12mm 4PCS screw M4*8mm 16PCS screw 6.2 Module parallel connection 6.21 Dimensions...
- Page 9 6.22 Operating steps（Let's take three parallel ones） 1.Connect the battery packs through a bracket and use M8 screws 2.Parallel connection...
- Page 10 3.Communication line parallel connection（RS485） Open the reset button respectively Turn on the switch separately 6.23 Dialing address selection...
-
Page 11: Slave Address
Definition of parallel dial switch：When the batteries are connected in parallel, the dialing switch is used to distinguish different pack addresses. The hardware address can be set through the dialing switch on the board. Single machine address setting：0000 0000 Address setting for parallel operation: the definition of dial switch is shown in the table below Slave address Add. -
Page 12: System Operation
Host address Number of Position Instruction parallel of dial machines switch 6.24 Dimensions 6.3 System operation... - Page 13 Wake up System will go to Sleep mode without load or charger for 48h. The following operations can be used to wake up： Automatically wakeup when connecting a charger； Press on the “reset” key for 3s； System standby and sleep Sleep mode：System will immediately go to Standby mode without load or charger, and RUN LED will flash (1s ON, 1s OFF).
- Page 14 Keep the battery against high temperature. Otherwise it will cause battery heat, get into fire or lose some function and reduce the life. When battery run out of power, please charge your battery timely (≤15day). Please use the matched or suggested charger for this battery. ...