Varma Tec HED66GBK-120PS Installation, Operation & Maintenance Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Quick Links

HELIOSA 66 BLACK
Installation, Operation & Maintenance Instructions
MODEL
HED66GBK-120PS
HED66GBK-120
HED66GBK20
Read Carefully – This instruction sheet contains vital information for the proper installation, use, and efficient operation of the
heater described. Carefully read this manual before installation, cleaning, or operation of the heater. Failure to adhere to the
instructions could result in fire, electrical shock, death, serious personal injury, or property damage. Save these instructions and
review frequently for continuing safe operation and instructing future users.
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE FOLLOWING:
1. Read all instructions before installing or using this heater.
2. All wiring must comply with the National Electrical Code (NEC) in the USA, Canadian Electrical Code (CEC) in Canada and all applicable
local codes.
3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, etc. and curtains at least 7 ft (2.1 M) from the front of the heater. See Fig. 2 for minimum mounting clearance
requirements.
4. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and
unattended. Note: this heater is for attended use only.
5. Inspect power cord regularly and do not use if damaged. Do not operate any heater if it is dropped or malfunctions in any way. Disconnect
power to heater and have it inspected by a reputable electrician before reusing.
6. This heater is approved for use in IPX5 Rated outdoor areas.
7. This heater is not intended for use in bathrooms, laundry areas and similar locations. Always disconnect power to heater before spraying
with water. Never locate heater where it may fall into or around water (including but not limited to bathtubs, sinks and water stalls).
8. Your heater is provided with a grounded 3-wire flexible cord suitable for hard wiring into an approved junction box. Make sure all
connections are tight.
9. Do not insert or allow foreign objects to enter heater as this may cause an electric shock, fire, or damage the heater.
10. To prevent a fire, use care to never block heater and maintain required clearances.
11. A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable vapors or liquids are used
or stored.
12. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or
injury to persons. Do not modify this heater in any way.
Via Pasubio 4/E 20067 TRIBIANO (MI) ITALY info@varmatec.com
VOLTS
WATTS
110-120V
1500W
110-120V
1500W
240V
2000W
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
60Hz
60Hz
50/60HZ
WARNING
VARMA TEC SRL
1
www.varmatec.com
3110043

Advertisement

Table of Contents
loading

Summary of Contents for Varma Tec HED66GBK-120PS

  • Page 1 12. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. Do not modify this heater in any way. SAVE THESE INSTRUCTIONS VARMA TEC SRL Via Pasubio 4/E 20067 TRIBIANO (MI) ITALY info@varmatec.com www.varmatec.com...
  • Page 2: Installation Instructions

    INSTALLATION INSTRUCTIONS Mounting Clearances Clearance to Combustibles Electrical Ratings Model Floor Ceiling Wall Front Sides (Nameplate) Volts Watts 110- HED66GBK-120PS 1500W 8" 120V 110- HED66GBK-120 1500W 8" 120V HED66GBK20 240V 2000W 8'3" 12" 36" 1. Carefully open the carton containing your heater and check for damage. If you find any damage, notify your carrier as freight damage is not covered by the manufacturer’s warranty.
  • Page 3 Figure 1...
  • Page 4 INSTALLATION TO WALL - THE HEATER MUST BE PLACED PERFECTLY HORIZONTAL AS PER THE DIAGRAM INSTALLATION MURALE - TOUJOURS PLACER L'APPAREIL HORIZONTALEMENT, COMME INDIQUE SUR LE SCHEMA (203mm) 1500W " (305mm) 2000W " (914mm) (914mm) " " 7Ft. (2,1 m) 1500W 8Ft.(2,5 m) 2000W MINIMUM SAFETY DISTANCES DISTANCE MINIMUM DE...
  • Page 5 ENGLISH: As wall materials vary, screws for fixing to wall are not included. For advice on suitable screw systems, contact your local specialised dealer. FRANÇAIS: Les vis et ferrures pour fixer le meuble/l’objet au mur ou au plafond ne sont pas incluses. Choisissez des vis et ferrures adaptées au matériau de votre mur.
  • Page 6: Wiring Instructions

    WIRING INSTRUCTIONS Note: Installer must determine how the heater will be controlled (ON-OFF) and provide branch circuit equipment as needed. This heater is provided with a section of weatherproof flexible power cable to allow for ease in wiring. Installer must bring branch circuit wiring to area near heater location and provide an approved junction box for making connections.
  • Page 7 MAINTENANCE INSTRUCTIONS REPLACEMENT OF THE EMITTER To be performed by qualified staff or specialized technician - Disconnect the heater from the power supply. - Assure the heater has been unplugged for at least 1 hour to cool down and avoid any possible burn situation. BULB REPLACEMENT 66GBK20 2000W CLEANING...
  • Page 8 GROUNDING INSTRUCTIONS This heater is for use on 120 volts. The cord has a plug as shown at A figure 1). An adapter as shown at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
  • Page 9: Instructions Importantes

    12. N’utilisez ce radiateur que comme c’est décrit dans ce manuel.Toute autre utilisation non recommandée par le constructeur peut causer un départ d’incendie, une commotion électrique ou des blessures corporelles. CONSERVEZ CES INSTRUCTIONS VARMA TEC SRL Via Pasubio 4/E 20067 TRIBIANO (MI) ITALY info@varmatec.com www.varmatec.com...
  • Page 10: Instructions D'installation

    INSTRUCTIONS D'INSTALLATION Mounting Clearances Clearance to Combustibles Electrical Ratings Model Floor Ceiling Wall Front Sides (Nameplate) Volts Watts 110- HED66GBK-120PS 1500W 8" 120V 110- HED66GBK-120 1500W 8" 120V HED66GBK20 240V 2000W 8'3" 12" 36" 1. Ouvrez avec précautions le carton contenant votre radiateur et contrôlez l’absence de dommages.
  • Page 11 Figure 1...
  • Page 12 INSTALLATION TO WALL - THE HEATER MUST BE PLACED PERFECTLY HORIZONTAL AS PER THE DIAGRAM INSTALLATION MURALE - TOUJOURS PLACER L'APPAREIL HORIZONTALEMENT, COMME INDIQUE SUR LE SCHEMA (203mm) 1500W " (305mm) 2000W " (914mm) (914mm) " " 7Ft. (2,1 m) 1500W 8Ft.(2,5 m) 2000W MINIMUM SAFETY DISTANCES DISTANCE MINIMUM DE...
  • Page 13 ENGLISH: As wall materials vary, screws for fixing to wall are not included. For advice on suitable screw systems, contact your local specialised dealer. FRANÇAIS: Les vis et ferrures pour fixer le meuble/l’objet au mur ou au plafond ne sont pas incluses. Choisissez des vis et ferrures adaptées au matériau de votre mur.
  • Page 14: Instructions De Câblage

    INSTRUCTIONS DE CÂBLAGE Remarque : L’installateur doit déterminer comment le radiateur sera contrôlé (Marche/Arrêt) et fournir l’équipement d’une banche de circuit secteur selon le besoin. Ce radiateur est fourni avec une section de câble d’alimentation flexible étanche pour faciliter le câblage. L’ installateur doit amener le câblage d’une branche de circuit secteur près de l’emplacement du radiateur et fournir un boîtier de raccordement approuvé...
  • Page 15 ENTRETIEN ET REMPLACEMENT DE L’AMPOULE Doit être effectuée par un personnel professionnellement qualifié. Pour remplacer l’ampoule, procéder de la manière suivante: 1. Débrancher complètement l’alimentation électrique. 2. Assurez-vous que l’appareil soit débranché au moins pendant une heure afin qu’il se refroidisse et évitez toute situation possible d’incendie.
  • Page 16 INSTRUCTIONS DE MISE A TERRE Ce chauffage est pour une utilisation à 120 volts. Le câble a une fiche, comme illustré sur la figure 1). Un adaptateur, comme indiqué en C, est disponible pour le raccordement des fiches à trois lames à des prises avec deux fentes.
  • Page 20 • THE MANUFACTURER DOES NOT GUARANTEE THE APPLIANCES IF THESE INSTRUCTIONS ARE NOT COMPLIED WITH. • LE CONSTRUCTEUR NE GARANTIT PAS LES APPAREILLAGES SI LES PRÉSENTES INSTRUCTIONS NE SONT PAS RESPECTÉES Nameplate CORD TAG HED66GBK-120...
  • Page 21 CORD TAG HED66GBK20 CORD TAG HED66GBK-120PS...
  • Page 22 Replacement of the appliance is excluded from this guarantee. The eventual repairs recognized in guarantee will be carried out free of charge for those appliances returned free VARMA TEC’s factory or to one of the authorized distributor. All transport costs are to be paid by the customer.
  • Page 24 VARMA TEC SRL Via Pasubio 4/E 20067 TRIBIANO (MI) ITALY info.it@varmatec.com www.varmatec.com EISTR66BKUSA ED.02.2022...

This manual is also suitable for:

Hed66gbk-120Hed66gbk20

Table of Contents