LOCATION OF PARTS AND CONTROLS
1 .
Wine Opener Top Button
2 .
Wine Opener Bottom Button
3 .
Foil Cutter
4 .
Charging Base
1
2
3
4
5
6
5 .
Charging LED
6 .
DC Jack (rear)
7 .
Wine Opener
8 .
Adapter
8
7
6
CHARGING THE UNIT
1 .
Plug one end of the ADAPTER cord into the DC JACK on the CHARGING
BASE and the other end into an outlet .
2 . Place the unit on the CHARGING BASE, ensuring that it's firmly
in position and fully engaged with the charging connectors . The CHARGING
LED will illuminate while the unit is charging . It will take approximately 6 hours
to charge .
3 . The Wine Opener will open approximately 50 bottles on a full charge .
IMPORTANT: The CHARGING LED must illuminate to ensure the unit is
charging correctly.
USING THE FOIL CUTTER
Before using the Wine Opener, remove any foil from the top of the bottle . Place the
FOIL CUTTER over top of the wine bottle and press the unit down to activate the
FOIL CUTTER .
USING THE WINE OPENER
1 .
Place the Wine Opener on the top of the wine bottle . Ensure that it remains as
upright as possible at all times . If the wine opener is held at even a slight
angle, the CORKSCREW will not remove the cork properly .
2 . While holding the bottle of wine and the Wine Opener firmly, press the WINE
OPENER BOTTOM BUTTON . The corkscrew will spiral in a clockwise direction
and pierce the cork, then gradually remove it from the bottle . When the
corkscrew stops, the cork has been fully removed from the bottle .
7