Table of Contents
Advertisement
12
www.electrolux.com
1
ø16
Connect the drain hose to the spigot and
tighten it with a clamp. Make sure that
the drain hose makes a loop to prevent
particles going into the appliance from
the sink.
6. Position the hose directly to a built-in
drain pipe in the room wall and tighten it
with a clamp.
5.3 Electrical connection
At the end of installation you can connect
the mains plug to the mains socket.
6. ACCESSORIES
6.1 Available in www.electrolux.com/shop or from authorised
dealer
Only appropriate accessories approved by ELECTROLUX ensure the
safety standards of the appliance. If unapproved parts are used, any
claims will be invalidated.
6.2 Fixing plate kit
If you install the appliance on a plinth
that is not an accessory supplied by
ELECTROLUX, secure the appliance in
the fixing plates.
7. CONTROL PANEL
7.1 Special features
Your new washer-dryer meets all modern
requirements for effective treatment of
2
W011
The rating plate and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are
compatible with the mains power supply.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the appliance to an earthed
socket.
The power supply cable must be easily
accessible after installing the appliance.
For any electrical work required to install
this appliance, contact our Authorised
Service Centre.
The manufacturer does not accept any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
Read carefully the instructions supplied
with the accessory.
laundry with low water, energy and
detergent consumption and detergent
consumption and proper care of fabric.
Advertisement
Table of Contents
