Table of Contents
Advertisement
Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
8 Disassembly and assembly / 8.8 Dismantling and fitting nozzle ring
at turbine end
1) If present
Check
© Copyright 2018 . All rights reserved.
Keep slots and spiral-wound gasket free of oil and grease.
u
NOTICE
Gas inlet casing with segment 51012
In the case of the gas inlet casing with segments, the segments are po-
sitioned with the aid of recesses and cams on the casing.
Coat the screw threads with high-temperature grease.
u
Fix a new spiral-wound gasket (61050) in the slot using a little super-
u
glue (for example "Loctite® 454 gel") applied at three evenly distrib-
uted points.
Position gas inlet casing complete with nozzle ring on gas outlet cas-
u
ing (61001).
Remove the two studs (90177) in the lower area.
u
Fit the segment (51012) with the recess on the cam on the gas inlet
u
casing and fit it loosely using screws (61044).
Put remaining segments (51012) in place on gas inlet casing (51001)
u
and fit them loosely using screws (61044).
HZTL2481_EN
Revision C
May 2018
Advertisement
Table of Contents
