CDI 116-7323 Installation And Troubleshooting Manual

CDI P/N: 116-7323
This unit replaces P/N: 817323A3, A4
Warning! This product is designed for installation by a professional marine mechanic. CDI Electronics cannot be held
liable for injury or damage resulting from improper installation, abuse, neglect or misuse of this product.
1. Disconnect and remove the old switch box.
2. Check for DC voltage on the kill (stop) wires (usually Black/Yellow) with the key-switch in the on and off position. At no time
should you see over 2 volts DC on this wire as severe damage to the power pack can occur.
3. Loosely attach the mounting plate to the switch box (Potted side) using the supplied screws.
4. Route the Green coil wires through the hole in the mounting plate.
5. Connect the trigger wires according to the color of the wires.
6. Connect the Black/Yellow wire to the Black/Yellow kill wire from the engine harness.
7. Slide the mounting bracket through the hole in the mounting plate so that the mounting bracket will clamp the mounting plate
when tightened.
8. Position the switch box as shown below and install the remaining mounting screw.
9. Tighten the two mounting brackets screws.
10. Connect the green coil wires to the coils.
11. Connect the Purple/White, Blue and Black wires to the Converter box.
CONNECTION LEGEND
Function
Coil #
1
Coil #
2
Coil #
3
Coil #
4
Coil #
5
Bias Circuit
Kill/Stop
Inverter Activation
High Voltage
Ground
CDI Electronics • 111 Commerce Circle • Madison, AL 35758 • Fax 256-772-5701 • www.cdielectronics.com
Installation and Troubleshooting Guide
All rights reserved. Reproduction or use of content, in any manner, without express written permission by CDI Electronics, Inc., is prohibited.
Color
Green
Green/White
Green/Red
Green/Black
Green/Yellow
White/Black
Black/Yellow
Violet/White
Blue
Black
Installation
Mounting bracket shown
Trigger Color
Brown
White
Violet
Black
Yellow
White/Black