Luminaire led Blade Series Installation Manual

Advertisement

INSTALLATION GUIDE FOR BLD

SAFETY PRECAUTIONS

WARNING - Risk of fire or electric shock. Basic safety precautions should always be
followed when using electrical equipment.
WARNING - This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
WARNING - Disconnect power to all circuits before wiring fixture.
WARNING - Install in accordance with all national, state, and local codes.
WARNING - Do not connect to an ungrounded supply.
WARNING - Read all fixture markings and labels to ensure correct installation of
fixture.
WARNING – Do not apply power to the fixture until the LED Board assembly is
connected to the driver. If power is applied to the fixture prior to connecting the LED
Board assembly to the driver, this will cause the LED Board to fail and void the
warranty.
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Blade Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Luminaire led Blade Series

  • Page 1 INSTALLATION GUIDE FOR BLD SAFETY PRECAUTIONS WARNING - Risk of fire or electric shock. Basic safety precautions should always be followed when using electrical equipment. WARNING - This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
  • Page 2 INSTALLATION GUIDE FOR BLD CAN ICES-005 (A) / NMB-005 (A) FCC COMPLIANCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 3 INSTALLATION GUIDE FOR BLD Figure 1 Figure 2 Fixture Housing Wall Mount Bracket Mounting Screws SITE PREPARATION INSTRUCTIONS 1. Mounting surface must be relatively flat. Split face block, natural veneer, or deep grout lines may require additional preparation such as concrete pads. 2.

This manual is also suitable for:

Bld series

Table of Contents