Advertisement
WARNING: DANGER OF EXPLOSION IF BATTERIES ARE INSTALLED INCORRECTLY.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANU-
FACTURER.
Keep away from small children. If Batteries are swallowed, promptly see a doctor.
Do not try to recharge these batteries. Disposal of used batteries must be made in accordance with
the waste recov-ery and recycling regulations in your area.
Note to Installer
Removing the 3-Second Delay on the Panic (
Changing the programming will affect operation. This should be done by the installer.
•
Press and hold all 4 buttons simultaneously until the LED begins to flash.
•
Press the Away key (
•
These are toggle features, to return to default, repeat the steps above.
NOTE: Do not press any other button while in Programming mode.
NOTE: For UL Listed installations, the 'Arm/Disarm Bell Squawk" feature of the control
panel must be enabled. The 3-second delay on the Panic key must not be disabled. The Bell
Squawk must be heard from outside the premises. Refer to the control panel's Installation
Manual for more information.
Belt Clip Assembly
Limited Warranty
Bentel Security srl. warrants that for a period of 12 months from the date of purchase, the product shall be free of defects in
materials and workmanship under normal use and that in fulfilment of any breach of such warranty, Bentel Security srl. shall, at its
option, repair or replace the defective equipment upon return of the equipment to its repair depot. This warranty applies only to
defects in parts and workmanship and not to damage incurred in shipping or handling, or damage due to causes beyond the control
of Bentel Security srl. such as lightning, excessive voltage, mechanical shock, water damage, or damage arising out of abuse,
alteration or improper application of the equipment.
The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other warranties, whether
expressed or implied and of all other obligations or liabilities on the part of Bentel Security srl. Bentel Security srl. neither assumes
responsibility for, nor authorizes any other person purporting to act on its behalf to modify or to change this warranty, nor to
assume for it any other warranty or liability concerning this product.
In no event shall Bentel Security srl. be liable for any direct, indirect or consequential damages, loss of anticipated profits, loss of
time or any other losses incurred by the buyer in connection with the purchase, installation or operation or failure of this product.
Warning: Bentel Security srl. recommends that the entire system be completely tested on a regular basis. However, despite frequent
testing, and due to, but not limited to, criminal tampering or electrical disruption, it is possible for this product to fail to per-form as
expected.
Important Information: Changes or modifications not expressly approved by Bentel Security srl. could void the user's authority
to operate this equipment.
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undes-
ired operation.
).
Compatibility
The WLBE400 is compatible with the following
receivers: VECTOR-8, VECTOR-VRX32 &
VECTOR-VRX32EN.
) Key
Advertisement
