Table of Contents
Advertisement
Sensors
en
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door
■
and detergent drawer open so that
any residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
If the display panel goes off at the
■
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
1. Activate setting mode for the signal volume
Set to Û.
20
Press and hold the 0 button + turn one
position to the right.
H
Sensors
A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum. ~ Page 25
M
Setting the signal
S e t t i n g t h e s i g n a l
Press and hold the button for approx.
five seconds until the display elements
light up. Setting mode is activated.
Advertisement
Table of Contents
