Download Print this page

Sealey CP72V Instructions page 2

Cordless caulking gun

Advertisement

2.
inTRODuCTiOn & SPECiFiCaTiOn
Well balanced cordless caulking gun with ergonomic handle. can dispense up to 15 cartridges on one charge. Accepts standard 310ml
cartridges up to 220mm length. Includes extra battery, charger unit and transformer plug. supplied in blow mould storage/carry-case.
Battery:. . . . . . . . . . . . . . . . . . . . . . 7.2V (0.8Ah)
speed: . . . . . . . . . . . . . . . . . . . . . 0-270mm/min
charge time: . . . . . . . . . . . . . . . . . . . . 3-5hours
Accessories:. . . . . . . . . . . . . . . . . .Extra Battery
Battery Model no: . . . . . . . . . . . . . . . . .cB7205
Weight Inc. Battery: . . . . . . . . . . . . . . . . . .2.0kg
3. OPERaTing inSTRuCTiOnS
note: When new, the battery pack will have been shipped in a low charge state. It will take longer to charge initially, and several subsequent
charges may also take a little longer than when the battery pack reaches its optimum performance. remove battery pack from case and
charge as below:
3.1.
CHaRging THE BaTTERY PaCk
3.1.1. Plug the Ac adaptor pin into the socket on the charging base and plug the adaptor into the supply wall outlet.
3.1.2. to remove the battery pack from gun, depress the two side release clips and withdraw battery from the gun handle.
WaRning! Do not touch metal terminals.
3.1.3. the battery pack and charger have the positive (+) and negative (-) terminals marked. Align the correct terminals and insert the battery
into the charger.
Note:
The battery pack is so designed that it will only enter the charger unit the correct way. When placed in the charger, a very slight
downward pressure will seat the pack firmly into the terminals. the red LED will light when the power supply is turned on to indicate
power supply is connected, green light will light to indicate battery is charging.
3.1.4. the charging will take approximately 3-5 hours from a fully discharged state. Do not leave on charge for longer than this period.
3.1.5 . After removing the battery, disconnect the charger from the mains supply and store in the carry case.
WaRning! never leave the battery unattended whilst charging due to the potential fire hazard.
Note:
If two batteries are to be charged in succession allow the charger to cool between uses.
Ac Adaptor
tube Holder
spare Battery
charging Base
Original Language Version
Plunger release switch
trigger
Plunger
Battery
cP72V
Issue: 2 - 26/10/09

Advertisement

loading