Intermatic FL250HPS Installation Instructions

A qualified electrician should complete all required wiring. Models FL250HPS, FL400HPS, FL250MH & FL400MH will
accept 120, 208, 240 or 277 Volts AC. Models FL250HSPT, FL400HPST, FL250MHT & FL400MHT will accept 120, 277
or 347 Volts AC. Fixtures must be properly grounded for safety. A mounting suitable for outdoor use and rated for wet
locations is required. Follow all applicable electrical codes and regulations.
Please see below for list of warnings.
WARNING Electric shock hazard
Disconnect power at circuit breaker or fuse box before
installing or servicing light.
WARNING Fire hazard
USE MIN 90°C SUPPLY CONDUCTORS. CONNECT TO
SUPPLY IN EXTERNAL JUNCTION BOX ONLY.
Lamp and housing become very hot during use. Ensure free
air circulation around unit to dissipate heat. Avoid enclosed
locations and locations where flammable debris (leaves, cut
grass, etc.) might collect. Avoid locations where humans or
animals might accidentally touch fixture.
WARNING Fire hazard
USE MINIMUM 125°C SUPPLY CONDUCTORS IF CORD
IS NOT USED.
WARNING Explosion hazard
Never operate light without securing the lens door. When
light is operating, the gas in the lamp inner arc tube is at
high pressure. Never operate light if the fixture lens or outer
glass envelope of the lamp is broken or missing.
WARNING Explosion hazard
Wear safety glasses and gloves when handling lamp, High
Pressure Sodium outer envelope is under vacuum and could
implode. Metal Halide outer envelope is pressurized and
could explode if broken.
WARNING UV hazard
The type of lamp used in this fixture can cause serious
skin burn and eye inflammation from short wave ultra
violet radiation if outer envelope of the lamp is broken or
punctured, and the arc tube continues to operate. Do not
use where people will remain for more than a few minutes.
Certain types of lamps that will automatically extinguish
when the outer envelope is broken or punctured are
commercially available.
ELECTRICAL REQUIREMENTS
WARNING
(Metal Halide Lamps Only)
HID Flood Light - FL Series
Models: FL250HPS, FL400HPS, FL250MH, FL400MH
FL250HSPT, FL400HPST, FL250MHT & FL400MHT
FOR OUTDOOR USE ONLY
NOT FOR USE IN HAZARDOUS
IMPORTANT: Read instruction sheet
carefully before installing fixture. Retain
instructions for future reference.
Lamp Types:
High Pressure Sodium 250 Watt & 400 Watt
High Pressure Sodium 250 Watt & 400 Watt with Tri-Tap
Metal Halide 250 Watt & 400 Watt
Metal Halide 250 Watt & 400 Watt with Tri-Tap
Trunion
Mounting
Bracket
Trunion
Bolt
MOUNTING & WIRING
1. Remove Trunion Bolts and positioning screw to free Trunion
Mounting Bracket.
2. Install Trunion Mounting Bracket to desired location. Fixture
should be horizontal when attached to mounting bracket.
(See Figure 2)
3. Loosen (2) screws and open Lens cover. Remove lens
cover and set aside to prevent damage during installation
of fixture.
4. Loosen (4) screws and remove reflector/lampholder
assembly.
5. Identify supply voltage.
Reflector
Lamp
Holder
Figure 2 (Mount Fixture horizontal)

INSTALLATION INSTRUCTIONS

ATMOSPHERES
Hinge
Figure 1
Lens
Cover
Screw
Positioning
Screw
4 ft. Outdoor
3-wire Cord