Advertisement
Quick Links
Solar Fountain Feature
Model: FOUNT-BALL-BK
Note:
1. Charge the pump unit for at least two days before the pump is used for the first time;
2. The LED light will work only when it's dark. If you want to test it in the daytime, turn the
solar panel upside down and minimise exposure to sunlight.
1 OVERVIEW
The solar pump is designed for fountain, pond or outdoor use. In order to make the solar pump
1.1
work, the solar panel needs to be in direct sunlight. When the sun light is strong enough, the
solar pump will start to work automatically. It will stop working when the solar panel is in
shadow or the sunlight is not enough. If the fountain is used in evening, four built-in white
LEDs will give light automatically to enhance the beauty scene of the water jet.
This solar pump is equipped with a battery pack. Extra electricity will be stored in the battery
1.2
pack and to be used when there is no enough sunlight or in night times. Press the button
(Switch), which is on the control house which is affixed to the rear side of the solar panel, to use
the stored electricity to power the pump.
2 ASSEMBLING AND USING YOUR PRODUCT
Unpack all components carefully. Please keep in mind that some water may splash over the rim
2.1
of a bowl, do not set up the cascade fountain on a surface which may be damaged by water.
Fill the fountain with clean tap water from the bowl.
2.2
Connect the rubber tube, which is from the upper bowl of the fountain, to the pump then place
2.3
the pump in water and make sure it is fully immersed in water.
Connect the pump cable to the socket of the control housing, which is on the rear side of the
2.4
solar panel;
Connect the LED light (optional) cable to the socket of the control housing;
2.5
Make sure direct sunlight shines on the solar module.
2.6
The solar fountain is now ready for use.
2.7
Advertisement
Summary of Contents for Gardeon FOUNT-BALL-BK
- Page 1 Solar Fountain Feature Model: FOUNT-BALL-BK Note: 1. Charge the pump unit for at least two days before the pump is used for the first time; 2. The LED light will work only when it's dark. If you want to test it in the daytime, turn the solar panel upside down and minimise exposure to sunlight.
- Page 2 Assembly 3 CAUTION 3.1 Do not strike the solar panel 3.2 Do not let the pump run dry for long time 3.3 Do not lift the pump by the power cord 3.4 Operate in freshwater only 4 OPERATING INSTRUCTIONS Automatic Operation: In this mode, the pump will start to work automatically when the solar panel gets enough direct sunlight and stop working when there is no enough sunlight on the panel.
- Page 3 Red: battery needs charges. Pump will run less than 1 hours. Note: The indicator light is blinking when the pump is on. Pump performance in different weather condition: Weather Performance of the pump Charging of the battery Solar energy runs the pump and charges the Battery will be fully battery at the same time.
- Page 4 No connection to the solar module – check connection to the solar module. Impeller is blocked – To clean the pump, remove the front plate and the impeller. Use a small brush or steam of water to remove any debris. 6.2 Pump does operate but there is no water running through the fountainhead check for the build up of sediment or scale in the tubes or the filter- clean the tubes and the filter.