OnFILTER CleanSweep AP LG Series User Manual

Specification
Rated Voltage, RMS
Rated Current, RMS
Power Line Frequency
Transient Signal Attenuation (Typical) 0.1/100 Ohms Interface
Differential Mode
Common Mode
Continuous Signal Attenuation (Typical) 0.1/100 Ohms Interface
Low Frequencies
High Frequencies
Power Indication
Dimensions (WxDxH)
Ambient Temperature
Climatic Category
Typical Performance of CleanSweep
Current from the iron's tip without CleanSweep
Filter Care
Normally, filter requires no maintenance and no calibration. It is recommended, though, to
periodically inspect filter for overheating and to clean its surface with dry cloth.
During its normal operation filter may have elevated temperature
which would feel "warm" to the touch, but not what is considered
"hot." If the filter does feel "hot" to the touch (more than 70
158 0 F), turn your equipment off, disconnect filter from the circuit
and discontinue using it. For warranty or other repairs contact
factory or its authorized distributors. Full text of warranty can be
found in the Library section at www.onfilter.com
4010859
Patent Pending. All specifications are subject to change without notice. Made in U.S.A.
4
110...250V AC (refer to filter's label)
3A
50/60 Hz
24dB
20dB
50dB
25dB
LED
3.12"x1.85"x5.0" ( 80x47x127mm)
0 0
+5 .. . 40 C
+05/040/00
®
Soldering Filter
®
filter Current from the iron's tip with CleanSweep
0 C or
OnFILTER, Inc.
730 Mission St. Ste.102
Santa Cruz, CA 95060 USA
Tel. +1.831.824.4052
Included:
FAX +1.206.350.7458
APxxxxLG Filter 1 ea.
www.onfilter.com
Power Cord 1 ea.
info@onfilter.com
CleanSweep
AC EMI Filters
for Soldering
APxxxxLG Series
®
filter
AC outlet may vary depending
on the specific model
®
User's Guide
1