DynaVap VapCap The VonG i How To Use

To use your VapCap:

1. Most Important! Before your first use, please read all of these instructions and then do at
least two, preferably more than two, dry runs with nothing in the VapCap! This is very
important to become familiar with the operation of the unit and prevent unintentional
combustion residues.
2. The VapCap is unlike any other vaporizer, so give it a few tries empty to get the feel of its
unique temperature-indicating click. Heat the VapCap in a quiet area, listen and feel so you
know what you are looking for. If you are using a torch lighter, this should not take more
than 5 or 6 seconds. Heat the middle of the cap not the end and rotate while heating. If more
than 6 seconds go by and you don't hear the click, stop heating and let it cool down.
3. If you severely overheat your VapCap it can be permanently damaged. It is very important
you hear the cool down click, or allow it to cool to the touch, before heating for the next
cycle. Repeat this procedure several times to get the feel of how this little unit operates.
4. When you are ready for the first use, let it cool down, then remove the cap from the VapCap.
5. Fill the VapCap chamber with your material of choice. This can be done easily by pushing the
VapCap into a container of your material and twisting. Pre-grinding your material is NOT
needed like when using a bat or hitter. If you prefer to grind, go coarse. Finely ground
material will get through the diffuser disc and into the unit.
6. Place the cap back on the VapCap.
7. Heat up the metal cap of your VapCap while rotating it, with the flame or heat source applied
to the last third of the metal cap. Try to only apply heat to the side of the cap and NOT the
end. This is not like lighting a smoking device.
8. Continue rotating and heating the cap until you hear and or feel a click - this means the
VapCap is ready!
9. Puff on the mouthpiece. Experiment a little here. If you draw with the air hole completely
plugged the flow will seem somewhat restricted. This is normal. Some find they get the best
result by taking a long, slow steady draw with the hole completely open, and others will
intermittently or lightly cover the air/vapor mix port. The way air flows through the VapCap
cools the vapor to provide a smooth experience.
10. Keep drawing as desired until you hear the click again, this means the VapCap has cooled
down.
11. When the vapor production diminishes, it is easy to reactivate. a. Make sure the VapCap has
re-clicked "to cool" before reheating for the next cycle. b. If you are not sure if it has re-
clicked, gently blow on the end to cool it. It may take up to 1 minute to reset.
12. When there is no longer any desirable vapor produced, and the cap has clicked "to cool",
remove the cap. The consumed material can be either blown out the end, or the little tang
on the cap is also a wonderful "digger outer."