VALLEY FORGE HECSFPL-12 Quick Start Manual

Model # HECSFPL-12
High End Commercial Solar Flagpole Light
Box contents:
1. Solar panel
2. Solar light with arm attached
3. (4) metal belts
4. Tube attachment for solar panel stake usage
5. Tube attachment for solar light stake usage
6. (2) stakes
7. Aluminum solar light bracket with arm attached
8. Aluminum solar panel brackett with arm attached
9. Small arm extension
10. Large arm extension
11. molly bolts and screws
1. SOLAR PANEL:
FRONT (FIGURE 02)
BACK (FIGURE 03)
2. SOLAR LIGHT:
WITH ARM
(FIGURE 04)
3. METAL BELTS
(FIGURE 05)
4., 5., 6. TUBES
AND SPIKES
(FIGURE 06)
7. SMALL
BRACKET
FOR LIGHT
(FIGURE 07)
9. SMALL ARM
EXTENSION
(FIGURE 09)
11. SCREWS
MOLLY BOLTS
(FIGURE 11)
Installation and Operation:
1. Remove solar panel from box FIGURE 02. Make
sure power button is in the OFF position (out and not
pressed in, FIGURE 12). The panel is shipped with the
switch in the "off " position. In order to determine the
position of the switch, place the solar panel face down
to block 100% of light reaching the panel. If light illumi-
nates, the switch is on. The solar panel will still charge
the battery even with the switch in the off position.
2. Place in direct sunlight panel-side up and charge for
48 hours.
FIGURE 12
1.
8. LARGE BRACKET
FOR SOLAR PANEL
(FIGURE 08)
10. LARGE ARM
EXTENSION
(FIGURE 10)