SOUTHPAW 7000 Instruction Sheet

Custom support system

Advertisement

Instruction Sheet
Custom Support System 7000
WARNING! Eye bolts will wear with use and must be inspected on a regular basis.
Discontinue use of eyebolt and replace immediately when wear begins to show. Do
not let wear exceed 30% of the eye bolt.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping. If
any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
Warning: Failure to properly install a forged steel eyebolt (1/2" or 5/8") may result in serious injury or death. If you have
any questions about the installation of the forged steel eyebolt, please contact Southpaw Enterprises Customer Service

MATERIALS LIST

2 - Padded Bases
2 - Padded Uprights
1 - Cross Beam with Eye Bolts
16 - 4-1/2" Bolts

TOOLS NEEDED FOR ASSEMBLY

2 - Wrenches (3/4" or adjustable)
Step Ladder
HEIGHT ADJUSTER OR SAFETY ROTATIONAL NEEDED
A Southpaw Safety Rotational Device (#2000) should be used with all
equipment to prevent damage to equipment. A Southpaw Height Adjuster
# 5000) will make adjusting the height of your equipment easier.
WORKING LOAD: 1500 lbs.

MAINTENANCE CHECKLIST

All of the following wear points should be checked on a daily, weekly or monthly basis (as indicated) and recorded on
the checklist enclosed.
Try to turn the eye bolt on a DAILY basis. If it turns at all, remove the eye bolt, coupling nut and lock nuts. Clean
each piece and then re-install per the directions using Loctite 242 threadlocker.
Check all nuts and bolts making certain that they are tight on a weekly basis.
WARNING: Check eye bolt for wear and movement. If more than 30% of the thickness of the eye bolt is worn
away (See fig. 1), discontinue use until replaced. If the eyebolt moves excessively, discontinue use until all hard-
ware is checked and tightened.
Use a Southpaw Safety Rotational Device (item #2000) to prevent abnormal wear and damage to equipment.
A small amount of grease at the point where the eye bolt and safety snap connect will greatly extend the life of the
eye bolt and safety snap.
16 - Positive Lock Nuts
24 - Washers
1 - Instruction Sheet
1 - Maintenance Checklist

CLEANING INSTRUCTIONS

Wipe with a damp cloth.
Store these instructions with the enclosed maintenance checklist in
a safe place. You may also access them on our website.
Wear pattern
Fig. 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7000 and is the answer not in the manual?

Questions and answers

Summary of Contents for SOUTHPAW 7000

  • Page 1 Warning: Failure to properly install a forged steel eyebolt (1/2” or 5/8”) may result in serious injury or death. If you have any questions about the installation of the forged steel eyebolt, please contact Southpaw Enterprises Customer Service MATERIALS LIST...
  • Page 2 Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition should this equipment be used without proper supervision.

Table of Contents