Summary of Contents for GiveBest GFI-2403-01
- Page 1 GiveBest ELECTRIC FIREPLACE WITH REALISTIC FLAME EFFECT USER MANUAL Model: GFI-2403-01...
- Page 2 When using electrical appliancces, basic precautions shoule always be followed to reduce reduce the risk of fire, electrical shock, and injury to persons including the following: Read all instructions before installing or using this heater. 2. DANGER-High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct the front of this heater.
- Page 3 15. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the appliance. 16. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where opening may become blocked.
- Page 4 LEG ASSEMBLE CAUTION - Risk of Fire - Do Not Operate Without Legs(Base) Attached Screw driver NOT included...
-
Page 5: Product Overview
PRODUCT OVERVIEW CAUTION – High temperature, keep electrical cords, drapery, and other furnishings at least 3 feet (0.9 m) from the front of the heater and away from the side and rear. Plug into an appropriate voltage AC 120V outlet, The unit will enter standby mode with display screen on red. -
Page 6: Remote Control
Flame Level Temperature 5. Timer 3. Flame speed Timer Flame Speed GiveBest BATTERY REPLACEMENT Replace with two 1.5V AAA batteries. 2 x AAA batteries Do not mix old and new batteries. Do not mix alkaline, standard(carbon zinc), or rechargeable(nicad, ni-mh,etc.) batteries. -
Page 7: Product Size
PRODUCT SIZE... -
Page 8: Operation
OPERATION 1. By Buttons on Control Panel Press the button to power on or off the unit. Press and hold about 10 seconds during powering on to lock the unit, the front flame effect display will flash. Hold again for about 10 seconds to unlock. Press the button repeatedly to switch to desired temperature from 17 to 27 (62 to 82... -
Page 9: Troubleshooting
TROUBLESHOOTING ISSUE POSSIBLE CAUSES SOLUTIONS Display shows “ ” The thermostat sensor Unplug the fireplace, remove the is broken or disconnected. back panel of the fireplace and check that the thermostat is plugged into the main circuit board. If this does not solve the problem, contact customer service for a replacement thermostat sensor. -
Page 10: Maintenance
Remote control is not working. No batteries Change the remote batteries. Remote control is not working. Poor signal Operate remote transmitter at a slow measured pace. Press the remote control buttons with an even motion and gentle pressure. Repeatedly pressing buttons in rapid succession may cause the transmitter to malfunction. - Page 11 2. Use of other parts or supplies(other than those sold by Brightown) that cause damage to the product. 3. If the product's model number or dating defaced, altered or removed. For customer service and warranty, contact us here support@brightown.com US +1 (888) 550 1319 Mon-Fri 8AM-10PM(EST) Brands Family: Brightown, Givebest Printed in China...
Need help?
Do you have a question about the GFI-2403-01 and is the answer not in the manual?
Questions and answers
Can i run the fire place without running the heater
Yes, the GiveBest GFI-2403-01 fireplace can be operated without the heater. The flame effect is energized whenever the on-off switch is in the on position, regardless of whether the heater is in use.
This answer is automatically generated
need new heating element