Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for RANSOM & RANDOLPH Neycraft
- Page 1 & R ANSOM ANDOLPH Instruction Manual Neycraft ™ duplicating unit 3535 Briarfield Boulevard, PO Box 1570 | Maumee, OH 43537 USA 800.253.4502 | 419.865.9497 | 419.865.9997 (FAX) | www.ransom-randolph.com Made in the USA Investing with Innovation™...
- Page 2 The Neycraft duplicating unit is innovative and user-friendly. It offers precise and reliable operation as well as an automated power saving on/off feature for an extended motor life. The Neycraft duplicating unit will run a complete cycle and return to holding temperature within 3 hours.
- Page 3 NOTE: To reset the timer function, turn the power OFF and then back ON. Temperatures for the Neycraft duplicating unit are preset at the factory to 194°F (90°C) for melting and 131°F (55°C) for holding. These temperatures can be manually changed to accommodate your needs. See instructions for Temperature Setting (under Factory Mode Status) below.
- Page 4 ™ EYCRAFT DUPLICATING UNIT 5. Once you have filled the machine with duplicating material, switch the power on. NOTE: ONLY OPERATE THE MACHINE WHEN THE LID IS SECURELY IN PLACE. To avoid serious bodily injury, never place fingers or hands into the machine while it is turned on. 6.
- Page 5 ™ EYCRAFT DUPLICATING UNIT Temperature Setting 1. On the control panel, push the ⑦ SET button. The Display Window will show the holding/constant temperature. 2. Push ⑤ UP or ⑥ DOWN button to set the desired HIGH/HEAT temperature. 3. Push the ⑦ SET button again to finalize the setting. 4.
- Page 6 ™ EYCRAFT DUPLICATING UNIT In Stop Mode Status, press the ⑦ SET button for 5-8 seconds to enter the setting mode. Use the ⑦ SET button to change the parameters. A small arrow will point to the current setting on the Display Window. Under the setting mode, press the ⑥ DOWN button to decrease the value or the ⑤...
- Page 7 ™ EYCRAFT DUPLICATING UNIT Safety Information Warning: It is strictly prohibited to disassemble the box body of the equipment and change the circuit of the equipment without the guidance of the R&R technical department. Unless advised to do so by both an R&R sales manager and technical representative, please do not touch the inner workings of the machine.
Need help?
Do you have a question about the Neycraft and is the answer not in the manual?
Questions and answers